Help and Comments www.waybasics.com/contact
version 0418
CAUTION placing unit on its side or back
will compromise structural integrity. Use
right side up.
Important
THIS SIDE UP
5
2
1
3
6
4
Carefully remove the protective
layer leaving the 3M adhesive
on zBoard (adhesive shown
in yellow). Place alignment pins
in vertical zBoards.
Align Vertical zBoard to backboard.
Fit backboard into Horizontal zBoard
groove.
Align Middle zBoard. Repeat steps 1-4 for next tier.
UNDER DESK SHELF
• Assemble your unit on a flat even surface
• Make sure zBoard surfaces are clean and dry
16 Pins
4 Vertical zBoards
adhesive on 2 sides
1 Middle zBoard 2 Horizontal zBoards
2 Back zBoards
WARNING: CHOKING HAZARD
Small parts NOT for children under 3 years
• When moving your Way Basics unit, lift from the bottom
• Indoor use only. Not in bathroom.
Included
Align Horizontal zBoard and press
firmly to secure unit together.
Enjoy building possibilities!
/
