CUSTOMER HELP LINE
USA 800-323-4329 • Canada 800-245-8777
Nissan
2005-08 FRONTIER
2009-13 FRONTIER
(SELECT MODELS)
2005-07 PATHFINDER (NO FACTORY NAVIGATION)
2008-12 PATHFINDER S
2004-14 TITAN
(BASE MODEL)
2005-08 XTERRA
2009-13 XTERRA
(SELECT MODELS)
Suzuki
2009-12 EQUATOR EXT CAB
VEHICLE APPLICATIONS
iNDK729
NDK729 Mounting Kit
©2015 AMERICAN INTERNATIONAL INDUSTRIES, INC.
TECH Ver. 11/13 PRINT Ver. 03/15
WWW.AIUS.NET
2500 East Francis Street Ontario, CA 91761, U.S.A.
USA Sales (800) 336-6500
Canada Sales (888) 922-3006
For information about other American International automotive
accessories visit our website at:
http://www.aius.net
D
IN
Sleeve
DIN MOUNT INSTALLATION INSTRUCTIONS
NOTE: REMOVE SHADED BRACKET TABS (Both L&R mounting brackets). SEE BELOW.
1. Attach the left and right side brackets to the main bracket.
2. Attach left and right side brackets to the rear of the pocket using screws supplied.
3. Insert DIN sleeve from your new radio into the upper section of the installation kit.
(This DIN sleeve comes with all new radios and slides off the back of the radio)
4. Depress the tabs from inside the sleeves opening upward, outward, and downward
to secure sleeve to the installation kit.
5. Install radio into sleeve and lock into place.
6. Support rear of radio with back strap (Optional).
IMB729
Left & Right
Mounting Brackets
NOTE: FOR NISSAN PATHFINDER. YOU MUST REMOVE THE CUP HOLDER
TRIM PANEL AND THE SHIFTER TRIM PANEL AND POCKET
1. Carefully remove the panel from the top of the radio.
2. Remove the (1) Phillips screw from the top of the Radio dash trim bezel.
3. Carefully lift upward from the bottom of the radio trim bezel, pull Radio trim bezel
forward and remove.
4. Remove the (4) Phillips screws securing the factory radio to the sub-dash.
5. Pull Radio forward, disconnect all harnesses and antenna lead from radio and
remove radio.
DASH DISASSEMBLY INSTRUCTIONS
Fig. A
2
IT
R
729
(
Opt
ional
Use)
REMOVE ALL SHADED
AREAS ON BOTH LEFT AND
RIGHT BRACKETS (LEFT
SIDE NOT SHOWN)
NISSAN FRONTIER NISSAN PATHFINDER (SEE DASH DISASSEMBLY NOTE)
NISSAN XTERRA SUZUKI EQUATOR
7
NOTES:
D
IN
Sleeve
ISO MOUNT INSTALLATION INSTRUCTIONS
NOTE: REMOVE SHADED BRACKET TABS (Both L&R mounting brackets). SEE BELOW.
1. Attach the left and right side brackets to the main bracket. See illustration below.
2. Attach left and right side brackets to the rear of the pocket using screws supplied w/kit.
3. Attach ISO Mount Spacers to the inside of upper section on both Left & Right
mounting brackets as shown in Figure B below.
4. Slide radio into kit from rear & attach to ISO mounting brackets using screws
supplied with radio when possible, or screws supplied with dash kit.
(do not tighten screws at this time). (Be sure the length of the screws DO NOT touch
any electrical parts inside radio, some screws may need to be shortened.)
5. Slide radio forward or backward for your desired look and then tighten the mounting
screws. Use ISO trim ring when possible.
6. Attach rear support strap to rear of pocket and to rear of radio (Optional).
DIN MOUNT INSTALLATION INSTRUCTIONS
NOTE: REMOVE SHADED BRACKET TABS (Both L&R mounting brackets). SEE BELOW.
1. Attach the left and right side brackets to the main bracket.
2. Attach left and right side brackets to the rear of the pocket using screws supplied.
3. Insert DIN sleeve from your new radio into the upper section of the installation kit.
(This DIN sleeve comes with all new radios and slides off the back of the radio)
4. Depress the tabs from inside the sleeves opening upward, outward, and downward
to secure sleeve to the installation kit.
5. Install radio into sleeve and lock into place.
6. Support rear of radio with back strap (Optional).
NOTE:
Optional ISO trim ring (ITR729 included) may be used in place of after-market radio’s trim ring.
For ISO mount applications, mount after-market radio to side brackets using hardware included.
For ISO mount: Attach (1) ISO Spacer to the
inside of upper section on both Left & Right
mounting brackets as shown in Fig. B.
Fig. B
IMB729
Left & Right
Mounting Brackets
M
a
in
Br
a
c
k
e
t
1. Carefully remove the panel surrounding the radio and climate controls.
2. Remove the (4) Phillips screws securing the factory radio to the sub-dash.
3. Pull Radio forward, disconnect all harnesses and antenna lead from radio
and remove radio.
DASH DISASSEMBLY INSTRUCTIONS
Fig. D
4 5
IT
R
729
(
O
pt
ional
Use)
IT
R
7
2
9
(Opti
o
n
a
l U
se
)
Fig. E
IMB729
Left & Right
Mounting Brackets
REMOVE ALL SHADED
AREAS ON BOTH LEFT AND
RIGHT BRACKETS (LEFT
SIDE NOT SHOWN)
REMOVE ALL SHADED
AREAS ON BOTH LEFT AND
RIGHT BRACKETS (LEFT
SIDE NOT SHOWN)
NISSAN TITAN ( BASE MODEL)
6 3
NOTES:
ISO MOUNT INSTALLATION INSTRUCTIONS
NOTE: REMOVE SHADED BRACKET TABS (Both L&R mounting brackets). SEE BELOW.
1. Attach the left and right side brackets to the main bracket. See illustration below.
2. Attach left and right side brackets to the rear of the pocket using screws supplied w/kit.
3. Attach ISO Mount Spacers to the inside of upper section on both Left & Right
mounting brackets as shown in Figure B below.
4. Slide radio into kit from rear & attach to ISO mounting brackets using screws
supplied with radio when possible, or screws supplied with dash kit.
(do not tighten screws at this time). (Be sure the length of the screws DO NOT touch
any electrical parts inside radio, some screws may need to be shortened.)
5. Slide radio forward or backward for your desired look and then tighten the mounting
screws. Use ISO trim ring when possible.
6. Attach rear support strap to rear of pocket and to rear of radio. (OPTIONAL)
NOTE:
Optional ISO trim ring (ITR729 included) may be used in place of after-market radio’s trim ring.
For ISO mount applications, mount after-market radio to side brackets using hardware included.
For ISO mount: Attach (1) ISO Spacer to the
inside of upper section on both Left & Right
mounting brackets as shown in Fig. B.
Fig. B
M
a
in
Br
a
c
k
e
t
IT
R
7
2
9
(Opti
o
n
a
l U
se
)
Fig. C
IMB729
Left & Right
Mounting Brackets
REMOVE ALL SHADED
AREAS ON BOTH LEFT AND
RIGHT BRACKETS (LEFT
SIDE NOT SHOWN)
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
American International TOYK994 User manual
-
American International LXSK1315 User manual
-
Metra 99-7417 Installation guide
-
-
Nissan 999F1-KV000 User manual
-
-
Metra 99-7606 User manual
-
Metra Electronics 99-7581 User manual
-
Metra Electronics 99-7431 Installation Instructions Manual
-
Scosche SI2228B User manual
