Rod Guide
Rod Guide (Provided with
exit device)
Extension Rod
(Both ends threaded)
Extension Rod Connector
Top Rod (Provided with exit device)
This end is not threaded.
Top Latch Connector
Extension Rod - Thread onto Latch Connector.
IMPORTANT: DO NOT CUT!
Top Rod (Provided with exit device)
IMPORTANT:
BE SURE TO ONLY CUT THE
END THAT IS NOT THREADED
!
Again, follow the 4500 or 4700 Exit Device
Installation Instructions, STEP 10 "Install Top Rod",
to install this rod connector and finalize top rod
installation.
STEP 1 STEP 2
STEP 3
STEP 4
Attach extension rod and top rod
(provided with exit device) by threading
the rods onto the extension rod
connector.
Thread rod assembly from STEP 1 halfway
onto Top Latch Connector.
Cut rod to the appropriate length by refering
to the 4500 or 4700 Exit Device Installation
Instructions, STEP 10 "Install Top Rod".
An extra Rod Guide is provided
with the extension rod kit. Install
once you reach STEP 13 "Install
Rod Guides", in the 4500
or 4700 Exit Device Installation
Instructions.
Possible height combinations with exit devices:
24” ext. rod + 7’ device = 8’ door
36” ext. rod + 7’ device = 10’ door *
24” ext. rod + 8’ device = 10’ door *
36” ext. rod + 8’ device = 11’ door *
* Can also be cut down to accommodate 9’ door.
Part No.
Description
4936
24 inch Extension Rod Kit
4937
36 inch Extension Rod Kit
HAGER COMPANIES
139 Victor Street, St. Louis, MO 63104 - (800) 325-9995 - Fax (800) 782-0149
4936 & 4937 EXTENSION ROD INSTRUCTIONS
FOR USE WITH THE 4500 AND 4700 SVR EXIT DEVICES
SHEET 1 OF 1
DRAWING NO: S-ED00925
REV: -
/
