Kichler Lighting 8654TZ User manual

Brand
Kichler Lighting
Model
8654TZ
Type
User manual

This manual is also suitable for

Kichler Lighting 8654TZ is a lighting fixture designed for indoor use. It comes with a mounting strap that can be attached to an outlet box, and mounting screws that can be inserted into the threaded holes in the mounting strap. The fixture has a ground wire that should be connected to the outlet box ground wire using a wire connector (not provided). The fixture also has black and white supply wires that should be connected to the black and white supply wires from the outlet box, respectively.

Kichler Lighting 8654TZ is a lighting fixture designed for indoor use. It comes with a mounting strap that can be attached to an outlet box, and mounting screws that can be inserted into the threaded holes in the mounting strap. The fixture has a ground wire that should be connected to the outlet box ground wire using a wire connector (not provided). The fixture also has black and white supply wires that should be connected to the black and white supply wires from the outlet box, respectively.

1) TURN OFF POWER.
IMPORTANT: Before you start, NEVER attempt any work
without shutting off the electricity until the work is done.
a) Go to the main fuse, or circuit breaker, box in your home.
Place the main power switch in the “OFF” position.
b) Unscrew the fuse(s), or switch “OFF” the circuit breaker
switch(s), that control the power to the fixture or room that
you are working on.
c) Place the wall switch in the “OFF” position. If the fixture to
be replaced has a switch or pull chain, place those in the
“OFF” position.
2) Attach mounting strap to outlet box. (Screws not provided)
3) Assemble mounting screws into threaded holes in mounting
strap.
4) Grounding instructions: (See Illus. A or B).
A) On fixtures where mounting strap is provided with a hole
and two raised dimples. Wrap ground wire from outlet box
around green ground screw, and thread into hole.
B) On fixtures where a cupped washer is provided. Attach
ground wire from outlet box under cupped washer and
green ground screw, and thread into mounting strap.
If fixture is provided with ground wire. Connect fixture ground
wire to outlet box ground wire with wire connector. (Not
provided.) After following the above steps. Never connect
ground wire to black or white power supply wires.
5) Make wire connections (connectors not provided.) Reference
chart below for correct connections and wire accordingly.
6) Push fixture to ceiling so mounting screws can pass through
keyhole slots. Turn fixture until screwheads appear as in detail.
Tighten screws.
7) Insert recommended lamp.
8) Screw hexnut on to threaded pipe and screw threaded pipe
into coupling on bottom of fixture body. Secure threaded pipe
in place by tightening hexnut against coupling.
9) Carefully lift glass over threaded pipe. Secure in place with
rubber washer, flat washer and hexnut. (DO NOT over tighten)
10) Slip trim pieces over threaded pipe and secure in place with
finial.
GREEN GROUND
SCREW
CUPPED
WASHER
A
B
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
(NOT PROVIDED)
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
MOUNTING STRAP
FIXTURE
Date Issued: 11/22/13 IS-8654-US
OUTLET BOX
GLASS
SCREW / KEYHOLE DETAIL
RUBBER WASHER
FLAT WASHER
HEXNUT
TRIM
FINIAL
HEXNUT
THREADED PIPE
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
  • Page 1 1

Kichler Lighting 8654TZ User manual

Brand
Kichler Lighting
Model
8654TZ
Type
User manual
This manual is also suitable for

Kichler Lighting 8654TZ is a lighting fixture designed for indoor use. It comes with a mounting strap that can be attached to an outlet box, and mounting screws that can be inserted into the threaded holes in the mounting strap. The fixture has a ground wire that should be connected to the outlet box ground wire using a wire connector (not provided). The fixture also has black and white supply wires that should be connected to the black and white supply wires from the outlet box, respectively.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents