AP-130-MNT-W1
Installation Guide
0510430-03 | September 2013 1
The AP-130-MNT-W1 Wall Mount kit allows you to mount your 130 Series access point to a wall.
1. Begin by attaching the wall mount adapter to the wall as shown in Figure 1 or Figure 2.
a. Install any necessary wall anchors. Wall anchors are not included in this kit.
b. Align the screw holes in the mounting bracket with the previously installed anchors or demarcated
screw points.
c. Insert the screws to secure the mounting bracket. Screws are not included in this kit.
Figure 1 Attaching the Adapter to a Wall
Figure 2 Attaching the Adapter to a Wall (Alternate)
AP-130_003
AP-130_006
2 AP-130-MNT-W1 | Installation Guide
2. Attach any necessary cables and/or antennas to the AP.
3. Attach the AP to the secured mounting adapter as shown in Figure 3.
a. Align the AP with a mounting adapter, placing the AP so that it’s mounting tabs are at an angle of
approximately 30 degrees to the adapter.
4. Pushing toward the wall, rotate the AP clockwise until it clicks into place (see Figure 3)
Figure 3 Attaching the AP to the Mounting Bracket
Figure 4 Completed Installation
AP-130_004
AP130_005
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Dell W-AP114/115 User guide
-
Dell W-IAP224/225 User guide
-
Dell W-AP224/225 User guide
-
-
-
Dell W-Series 228 Access Points Owner's manual
-
-
Dell W-7010 Owner's manual
-
-
Dell W-7030 Owner's manual
Other documents
-
Aruba AP-220-MNT-W2 Installation guide
-
Alcatel-Lucent OAW-AP228 Installation guide
-
Taylor BC10 User manual
-
Meru Networks 4339B Installation guide
-
Cisco ASA 5506-X Mount And Connect
-
Aruba Networks AP-200-MNT-W2 Installation guide
-
Motorola ABZ89FT7636 User manual
-
Wirepath Surveillance WPS-MNT-L-DOM-BL Owner's manual
-
Grindmaster 6321L User manual
-
