User Manual
LED Karaoke Microphone
Model：8736
Accessories:
1* Microphone
1* User Manual
1* Charging Cable
1* Aux cable
Features:
BT/USB/Raibow LED/AUX/TF Card
Technical Parameters:
● BT Version: V5.0
● Polar Pattern: Omni-Directional
● Output Power：3 W
● Speaker：40 mm 4Ω 3 W
● Lithium battery：800 mAh
● Transmission distance: 10 m
● Frequency Range:100Hz-10KHz
● DC/5V: input DC 5V/0.5A
● Charging time: 2-3 hours
● Stand-by time: 180 hours
● Charging Interface: Micro USB(30 cm length)
● Play time: 3-4 hours (50% volume)
● Material: ABS Plastic+Aluminum Alloy
●Product size :φ8 * 25. 5 CM , 267g
Button Operation (subject to actual product)
1. Charging port-Micro USB ;
2. Short press to pause, and long press to change the
tone;
3. Microphone volume +/-;
4. "＜" Long press to decrease the volume, short press
for previous song;
5. Short press to change mode(BT/Recording ),long
press to change the led light;
6.USB port,plug into USB disk to play music;
7. AUX port, plug into to line in;
8. TF/SD card port,plug into TF/SD card to play music;
9. Remix depth +/- ;
10."ON/OFF" , Turn on and switch off ;
11."＞" Long press to increase the volume, short press
for next song;
12. Short press to eliminate original sing.
Charging Instructions
Connect charging cable to the 5V-1A mobile phone charger for
charging. The indicator turns red during charging, and red
indicator turns off when fully charged.
Using the Environment & Storage Environment
1.Operating environment
Temperature: 0-40 ℃，Humidity : 0-85% RH
2.Storage environment
Temperature: 30-60 ℃，Humidity : 0-95% RH
Safety Instructions
1. DO NOT DROP, APPLY EXCESSIVE FORCE TO THE CONTROLS, OR
PUT HEAVY OBJECTS ON TOP OF THE BT SPEAKER.
2. DO NOT ATTEMPT TO REPAIR, DISASSEMBLE OR MODIFY THE
PRODUCT. There are no user-serviceable parts inside this unit.
3. Close supervision is necessary when any appliance is used by
or near children under the age of 7.
4.If you do not use the microphone for long periods of time,
be sure to store it in a dry place.
5. Keep the microphone away from any heat source.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could
void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.
FCC Statement
/
