Avaya BSG12ew/aw/tw Quick Installation Guide

Brand: Avaya

Model: BSG12ew/aw/tw

Type: Quick Installation Guide

BSG12

BSG12ew/aw/tw WiFi Module

Replacement Guide

You can download all documents referenced in this Quick Install Guide at www.nortel.com.

BSG12 WLAN

48V DC Modem

WiFi module

Power down the BSG12 unit.

Before you shut down the BSG12 unit, you must save the running configuration. To use the WebUI to save the running

configuration, go to Step 2. To use the CLI to save the running configuration, go to Step 4.

Slide the BSG12 WiFi Replacement Module

(NT5S21ZCE6) into the WiFi module slot.

Use a Phillips screwdriver to retighten the

screws on either side of the WiFi module. Do

not overtighten the screws.

Power up the BSG12 unit.

Reattach the two antennas.

Refer to the Quick Installation Guide for your BSG12 model and complete the steps to configure

the initial system settings in the BSG WebUI.

To complete the basic WiFi

configuration, in the WebUI,

navigate to

Configuration>LAN>Wireless

>Basic Settings. In the

Access Point field, ensure that

Enabled is selected. From the

Country Code list, ensure that

the correct country is selected.

Navigate to the SSID tab. Ensure that the preconfigured BSG_11G_SSID_0 is enabled.

Verify that your wireless-capable PC or laptop can

connect with the broadcast SSID and enable

network connectivity.

N0174560

NN47928-309

Standard 01.01

Unscrew and remove the two antennas.

Use a Phillips screwdriver to remove the screws on

either side of the WiFi module. You will feel the screws

disengage when you have sufficiently loosened them.

From the BSG12 WebUI logon page, log on using the user ID nnadmin and the password PlsChgMe!.

From the left-hand navigation panel navigate

to Administration>Configuration

File>Save. Click Apply. Go to Step 6.

Launch an SSH session. Log on to the BSG12

unit using the user ID nnadmin and the

password PlsChgMe!.

At the BSG# prompt enter the write startup-config

command.

Gently remove the WiFi module from the faceplate.

Tools and materials

Replacing the WiFi module

Saving the running configuration to Flash

Verifying the WiFi installation

Before you replace the BSG12 WiFi module, open the box for the BSG12 WiFi Replacement Module and

ensure you have the following package contents.

Package Contents

● BSG12 WiFi Replacement Module (NT5S21ZAE6)

Tools

You require the following tools to complete this replacement procedure:

● Phillips screwdriver

● antistatic grounding strap

● grounding source

48V DC Modem

BSG12 WLAN

48V DC Modem

BSG12 WLAN

Risk of equipment damage The WiFi replacement module must be contained in an an antistatic bag at all times.

Before you remove the WiFi replacement module from the bag, you must wear an antistatic grounding strap that is

attached to a grounding source.

Risk of equipment damage

You must wear an antistatic grounding strap at all times when handling electronic components. The antistatic

grounding strap must be connected to a grounding source. Failure to do so can result in damage to the equipment.

Avaya BSG12ew/aw/tw Quick Installation Guide

Avaya BSG12ew/aw/tw Quick Installation Guide

Avaya BSG12ew/aw/tw Quick Installation Guide

Related papers

Other documents