HP 1000s Reference guide

Brand: HP

Model: 1000s

Category: Rack consoles

Type: Reference guide

Hewlett-Packard Company makes no warranty of any kind with regard to

this material, including, but not limited to, the implied warranties of merchantability

and fitness for a particular purpose. Hewlett-Packard shall not be liable for errors

contained herein or for incidental or consequential damages in connection with

the furnishing, performance, or use of this material.

This document contains proprietary information, which is protected by copyright.

No part of this document may be photocopied, reproduced, or translated into

another language without the prior written consent of Hewlett-Packard. The

information contained in this document is subject to change without notice.

Hewlett-Packard Company shall not be liable for technical or editorial errors or

omissions contained herein. The information is provided “as is” without warranty of

any kind and is subject to change without notice. The warranties for Hewlett-

Packard Company products are set forth in the express limited warranty statements

accompanying such products. Nothing herein should be construed as constituting

an additional warranty.

hp StorageWorks

NAS 1200s

Rack

Installation

Instructions

WARNING: Before you begin, make sure that the rack is

sufficiently stable. If provided, lower the rack leveler feet and

make sure any required stabilizers are installed. If provided,

extend the rack anti-tip device. Failure to extend the anti-tip

device could result in personal injury or damage if the rack tips

over.

CAUTION: Make sure that the rack and all equipment

mounted in the rack have a reliable ground connection. Verify

that the total current of the rack components does not exceed

the current rating of the power distribution unit or outlet

receptacles.

2 Install the Rails

1 AC power plug

2 Mouse connector (green)

3 Video connector (blue)

4 Serial port (teal)

5 PCI expansion slot

6 LVD SCSI Controller connector

7 RJ-45 connector for NIC 1

8 RJ-45 connector for NIC 2

9 USB connectors (2) (black)

- Keyboard connector (purple)

Contents Front and Rear Views

1 Power button

2 Power on

3 Status

4 NIC 1 and NIC 2 status

5 Hard disk status (4)

6 Hard disk access (4)

1 Prepare the Rack

1. Use the template to locate and mark the holes (using a pencil)

where the cage nuts need to be installed on the vertical rails of

the rack.

3 Prepare the Server

1. Install the slide rail assemblies as shown using the supplied

screws.

IMPORTANT: Leave the screws in the back a little loose until the server

is completely installed and has been moved in and out of the rack a few

times. This allows the rails to position properly and prevents binding.

Once step 4, “Install the Server” is complete, tighten the screws

completely.

Warnings and Cautions

HP StorageWorks NAS 1200s Rack Installation Instructions

First Edition (May 2003)

Part Number: 351699-001

1 Rack Template

2 Inner slide rails

(removed for clarity)

3 Outer slide rails

4 Cable management arm

5 NAS 1200s server

6 Velcro straps

7 Cage Nuts

8 Thumbscrew brackets

9 Assorted screws (not shown)

2. Install the cage nuts as shown.

1. Remove the inner slides from the slide rail assemblies.

a. From the front of the rack, extend the inner slide rails until

they lock in place.

b. Press the inner slide lock (green tab) down to release and

then pull the inner slide rail straight out.

2. Attach the two thumbscrew brackets to the server using the

supplied screws, as shown.

2 5

10 9

3 4

8 7

3. Attach the inner slide rails to the server using the supplied

screws, as shown.

351699-001