Polaroid Portable Power Pack User manual
- Category
- Mobile device chargers
- Type
- User manual
Polaroid Portable Power Pack is designed to charge mobile devices while on the go. It features two USB ports with a total output of 2.1A, allowing you to charge two devices simultaneously. The power pack has a capacity of 10400mAh, which is enough to charge a typical smartphone multiple times. The LED flashlight can be used as an emergency light source. The power pack is compact and lightweight, making it easy to carry in a backpack or purse. It comes with a micro USB cable for charging the power pack itself.
Polaroid Portable Power Pack is designed to charge mobile devices while on the go. It features two USB ports with a total output of 2.1A, allowing you to charge two devices simultaneously. The power pack has a capacity of 10400mAh, which is enough to charge a typical smartphone multiple times. The LED flashlight can be used as an emergency light source. The power pack is compact and lightweight, making it easy to carry in a backpack or purse. It comes with a micro USB cable for charging the power pack itself.
PPP1010
Micro USB Charging Cable
User Manual
USB
PORTABLE POWER PACK
{
FOR SMARTPHONES
}
PPP1010 | USER MANUAL
Questions?
Need some help?
This manual will help you
enjoy your new product
If you still have questions,
call our help line:
1-877-768-8481
or visit us at:
Click on “Product Support”
www.southerntelecom.com
{ 10400mAh }
Portable Power Pack
PORTABLE POWER PACK
PPP1010 | USER MANUAL
To charge the Portable Power Pack:
1. Connect the small end of the included Micro USB cable to the Micro
USB input charging port on the Portable Power Pack.
2. Connect the large end of the included Micro USB cable to an available
USB port on your computer or an AC power adapter (not included).
3. The LED power level status lights will flash while the Portable Power
Pack is charging.
4. The LED power level status lights will all light up solid BLUE when fully
charged (approx. 6-8 hours).
5. When done charging, remove the cable from the ports.
Checking the capacity of the Portable Power Pack:
Press the [ ] button to check the power capacity. The power level status
LEDs will light up according to available power capacity.
This product as supplied and distributed new by AIT, Inc. (“AIT”) to the original consumer purchaser
is warranted by AIT against defects in material and workmanship for a period of one year from your
date of purchase (“Warranty”).
In the unlikely event that this product is defective, or does not perform properly, you may within one year
from your original date of purchase return it to the authorized service center for repair or exchange.
TO OBTAIN WARRANTY SERVICE:
• Call the Customer Support number located below, or go to our website portal to receive an SRO
number.
• Provide proof of the date of purchase within the package (Dated bill of sale).
• Prepay all shipping costs to the authorized service center, and remember to insure your return.
• Include a return shipping address (no P.O. Boxes), a telephone contact number, and the defective
unit within the package.
• Describe the defect or reason you are returning the product.
Your product will be repaired or replaced, at our option, for the same or similar model of equal value
if examination by the service center determines this product is defective. Products received damaged
as a result of shipping, will require you to file a claim with the carrier.
The shipping address of the authorized service center is:
AIT, Inc.
ATTN: Customer Service (2nd Floor)
14-C 53rd Street
Brooklyn, NY 11232
IN NO EVENT WILL AIT, ITS MANUFACTURERS, DISTRIBUTORS OR PLR IP HOLDINGS, LLC BE
LIABLE FOR ANY INCIDENTAL, DIRECT, INDIRECT, SPECIAL, PUNITIVE OR CONSEQUENTIAL DAMAGES
(SUCH AS, BUT NOT LIMITED TO, DAMAGES FOR LOSS OF PROFITS, BUSINESS, SAVINGS, DATA OR
RECORDS) RELATED TO THIS PRODUCT. EXCEPT AS STATED HEREIN, NO OTHER WARRANTIES
SHALL APPLY.
Questions?
Need some help?
This manual will help you
enjoy y our new product
If you still have questions,
call our help line:
1-877-768-8481
or visit us at:
Click on “Product Support”
www.southerntelecom.com
1
2
3
1. Micro USB input charging port - for charging the Portable Power Pack
2. LED Flashlight
3. LED power level status lights
4. USB output charging ports (2.1A total) - for charging any device,
including tablets, smartphones, etc.
5. [ ] button:
• Start charging
• Power/flashlight ON/OFF
• Power capacity check
Caution: Any changes or modifications not expressly approved could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
PLR IP Holdings, LLC, its licensees and affiliates, fully support all electronic waste initiatives. As responsible
stewards of the environment, and to avoid violating established laws, you should properly dispose of this product
in compliance with all applicable regulations, directives or other governances in the area where you reside. Please
check with local authorities or the retailer where you purchased this product to determine a location where you can
appropriately dispose of the product.
Charging the Portable Power Pack
Charging Other Devices
USB OUTPUT
CHARGING PORTS
MICRO USB INPUT
CHARGING PORT
PC
LOCATION OF CONTROLS CHARGING THE POWER PACK
LIMITED WARRANTY
IN THE BOX
USING THE POWER PACK (cont’d) USING THE POWER PACK (cont’d)
To charge two or three devices with the Portable Power Pack:
If you are trying to charge two or three devices at the same time, the devices
you are charging must have over 30 percent capacity. If you have two or three
devices plugged into the Portable Power Pack and the devices are not
charging, then follow these steps:
1. Unplug devices from the Portable Power Pack.
2. Plug the Portable Power Pack back into a charging source for 10 seconds
or more to restart it.
3. Charge one device at a time.
4. Once your devices are over 30 percent capacity you can charge them at the
same time.
NOTE: Some newer smartphones require the charging Amperage of
tablets. If the Portable Power Pack will not charge two or three devices each
time you try, then repeat steps one through three above and always charge
them one at a time.
Activating the LED Flashlight
To use the LED flashlight, double press the [ ] button to turn it on. Double
press again to turn it off.
Questions?
Need some help?
This manual will help you
enjoy y our new product
If you still have questions,
call our help line:
1-877-768-8481
or visit us at:
Click on “Product Support”
www.southerntelecom.com
4
5
<25% capacity 25-50% capacity 50-75% capacity >75%capacity
To charge devices with the Portable Power Pack:
1. Connect the USB end of your device’s charging cable to a USB output
charging port on the Portable Power Pack.
2. Connect the other end of your device’s charging cable to your device’s
charging port (please refer to your device’s user guide for charging
instructions). You can charge up to three devices at the same time.
NOTE: The Portable Power Pack shares a total of 2.1A power output between
the three USB output ports. If you charge one device, the output will be 2.1A.
If you charge two devices, it will split the 2.1A between the two devices; if
you charge three devices, it will split the 2.1A between the three devices.
3. Press the [ ] button to start charging your devices.
4. Use your device’s battery indicator to determine when the device is fully
charged.
5. When your device is fully charged, remove the cable from the ports.
USING THE POWER PACK
The 2.1A Portable Power Pack is suitable for charging
tablets and larger smartphones. If a tablet or large
screen smartphone is being charged, it is recommended
to charge only this device. If three devices are being
charged at the same time, they should be smaller
devices such as smartphones, MP3 players, wireless
headphones, etc.
{ 10400mAh }
PPP1010
-
1
-
2
Polaroid Portable Power Pack User manual
- Category
- Mobile device chargers
- Type
- User manual
Polaroid Portable Power Pack is designed to charge mobile devices while on the go. It features two USB ports with a total output of 2.1A, allowing you to charge two devices simultaneously. The power pack has a capacity of 10400mAh, which is enough to charge a typical smartphone multiple times. The LED flashlight can be used as an emergency light source. The power pack is compact and lightweight, making it easy to carry in a backpack or purse. It comes with a micro USB cable for charging the power pack itself.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Noblesse DOTWACBTX16001 User manual
-
Sharper Image Smartphone Battery Backup Owner's manual
-
DreamGEAR ISOUND-4579 Datasheet
-
Promate STORM.15 User guide
-
Goal Zero Venture 30 User guide
-
SereneLife SereneLife SLSPGN20 User manual
-
RAVPower RP-PB19 User manual
-
Impecca CTJK-2436O User guide
-
NOCO GB40 Boost Plus 1000A Jump Starter User manual
-
Jackery by Honda EXPLORER440 User manual
