Ingenico RP457c Quick start guide

Category
Bluetooth music receivers
Type
Quick start guide
Ingenico RP457c Quick Start Guide
RP457c (front) RP457c (back)
2 Assemble your RP457c card reader
You will find your card reader and an audio connector in the package,
along with a rubber bumper and a rubber stabilizer. Plug the audio con-
nector into the card reader. Use the rubber bumper and stabilizer to ensure
your card reader sits securely on your mobile device. Select the port that
best fits your mobile device.
1 Gather everything you need to get started
1 Converge Mobile app downloaded on your mobile device
2 Ingenico RP457c card reader
3 A Converge Mobile account
4 An iOS/Android mobile device with internet connectivity
1 2
Account
Username
PIN
3 4
Audio connector
Rubber stabilizer (bottom)
Rubber stabilizer (bottom) RP457c with audio connector and
rubber bumper and stabilizer
Rubber bumper (front) Rubber bumper (back)
3 Charge your RP457c card reader
Charge your RP457c with the USB cable by plugging it into a charger or
computer. You will find three sets of lights on the card reader.
Red LED battery indicator (on the right) above the power button:
Battery full - red LED is ON and steady
Battery low - red LED blinking slowly
Battery out of capacity - red LED is OFF
Battery charging - red LED blinking quickly
Blue Bluetooth LED indicator (on the left) below the USB port ON:
Bluetooth device is connected
Four LEDs on the top are transaction status indicator
Four LED lights
(transaction indicator)
Red LED
(battery indicator)
USB port
Power button
Blue LED
(Bluetooth indicator)
Recommended alignment Awkward alignment
4 Set up Converge Mobile with RP457c
Download and launch the Converge Mobile app on your mobile device. You
can find the Converge Mobile app in the Apple App Store or Google Play
Store by searching for “Converge Mobile.”
Log in using your Converge Mobile account credentials. If you are an exist-
ing VirtualMerchant Mobile or Merchant Services Mobile user, you can use
the same log-in credentials for Converge Mobile. If you do not have log-in
credentials, contact the Activation team at 866-451-4007.
Once logged in, select the RP457c on the card reader selection screen.
Follow the steps to user your RP457c with the audio jack or pair it as a
Bluetooth card reader.
5 Accept payments with your RP457c card reader
After setup, you can accept payments by inserting a chip card, tapping a
contactless card or mobile wallet, or swiping a magstripe card.
© 2016 Elavon, Inc. All rights reserved. Elavon is a trademark in the United States and other countries. Converge is a
registered trademark in the United States. Bluetooth is a registered trademark of Bluetooth SIG, Inc. All features and
specifications are subject to change without notice. SFT-SOLS-1675-US-Sept16
1234
****
Pay
with
Touch
ID
Insert a chip card
(EMV transaction)
Take contactless
payment
Swipe a magstripe card
(either left to right
or right to left)
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Ingenico RP457c Quick start guide

Category
Bluetooth music receivers
Type
Quick start guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI