Ford 2014 E-Series User manual

Hello! I've reviewed the user manual for the Ford E-Series E-350's selector lever cable adjustment. The document details the steps for adjusting the cable for both the 4R75E and TorqShift transmissions, including lever positioning and cable handling. I am ready to answer your questions about this process.
What position should the vehicle be in when starting the procedure?

What position should the selector lever be placed in?

What weight should be applied to the selector lever?

What should be done to prevent selector lever cable damage?

What are the steps to set the manual control lever for the (D) position?

What should be checked after installation?

6/25/2021

Automatic Transaxle/Transmission External Controls - Selector Lever Cable Adjustment - General Procedures • 2014 Ford E-350 • MotoL…

https://www.motologic.com/car/2014_fd_e-350_5393/article/2014_fd_e-350_5393_3d8caf7b8bb5e39e6a5abe913907b38f?returnPath=%2Fcar%2F20…

1/2

Report a problem with this article

Automatic Transaxle/Transmission External Controls - Selector Lever Cable Adjustment -

General Procedures

307-05 Automatic Transaxle/Transmission External Controls 2014 E-Series

GENERAL PROCEDURES Procedure revision date: 09/05/2013

Selector Lever Cable Adjustment

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.

2. Place the selector lever in the (D) position.

Place a 1.3 kg (3 lb) weight on the selector lever.

3. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between

the manual control lever and the selector lever cable bracket.

Disconnect the selector lever cable from the manual control lever.

4. Unlock the lock tab on the selector lever cable.

5. For either automatic transmission, place the manual control lever in the (D) position.

1. Place the manual control lever in the 1st gear position.

2. Move the manual control lever 2 detents to the (D) position for the 4R75E transmission. Move the

manual control lever 3 detents to the (D) position for the TorqShift® transmission.

6/25/2021

Automatic Transaxle/Transmission External Controls - Selector Lever Cable Adjustment - General Procedures • 2014 Ford E-350 • MotoL…

https://www.motologic.com/car/2014_fd_e-350_5393/article/2014_fd_e-350_5393_3d8caf7b8bb5e39e6a5abe913907b38f?returnPath=%2Fcar%2F20…

2/2

6. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between

the manual control lever and the selector lever cable bracket.

NOTE: When installing the selector lever cable end, make sure that the selector lever cable end is correctly

installed onto the manual control lever ball stud. Pull back on the selector lever cable to make sure that the

selector cable end is correctly installed onto the manual control lever ball stud.

Install the selector lever cable end onto the manual control lever ball stud.

7. Lock the transmission selector lever cable lock tab.

8. Remove the weight.

9. Carefully move the selector lever from detent to detent and compare with transmission settings. Verify that the

vehicle will start in PARK or NEUTRAL and reverse lamps illuminate in REVERSE. If not, Steps 1 through 5

must be repeated and for the 4R75E transmission, include Transmission Range (TR) sensor adjustment in

NEUTRAL. Readjust if necessary.