Page is loading ...
3-in-1 Sky Moon Light (Wi-Fi)
User Manual
LED
EN
DE
FR
ES
IT
JP
LED
EN
DE
FR
ES
IT
JP
3
EN
DE
FR
ES
IT
JP
1
2
LED
1
2
3
5
4
6
EN
DE
FR
ES
IT
JP
3
4
5：
6：
EN
DE
FR
ES
IT
JP
FADE
H
LED
FADE
FADE
LED
H
FADE
6
EN
DE
FR
ES
IT
JP
Smart Life Tuya Smart
；
7
EN
DE
FR
ES
IT
JP
APP Functions
8
EN
DE
FR
ES
IT
JP
9
EN
DE
FR
ES
IT
JP
Connect to Amazon Alexa:
EN
DE
FR
ES
IT
JP
Specifications
EN
DE
FR
ES
IT
JP
Start voltage is 3Ⅴ, with 1-4 r/min
℃
℃
＜0.4mW
FOR SAFETY’S SAKE:
The light colour of this product is outside the limits as defined in ErP Regulations
and therefore only suitable for decorative purposes.
Complies with safety requirements of IEC 60825-1：2014
Not suitable for use in play by children
May not be suitable for people who have photo sensitive epilepsy
AVOID DIRECT EYE EXPOSURE
[Class 1] LASER RADIATION - DO NOT STARE INTO BEAM - CLASS 1 LASER
PRODUCT
Do not damage the insulation of cable.
Do not secure the wiring of the product with staples or nails
Do not close doors or windows on the product as this may damage the wiring
insulation.
Do not lay the cable under carpet or where it can be damaged.
Ensure that cables are fully unwound and sited where they will not become
damaged or present a tripping hazard.
Do not connect this product to the mains supply while it is in the packaging.
Do not allow any plastic part to come into contact with heat or flame.
Ensure table top transformers are positioned on flat, stable, heat resistant
surfaces.
Unplug the product when leaving the house, when retiring for the night or if left
unattended
Do not overload wall sockets. Use different sockets around the house to plug in
multiple lights to balance the load.
Please retain this information for future reference.
FCC Warning:
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
“This equipment complies with RF radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.”
/
