2. Jabra
  3. PanaCast 50
PanaCast 50

Jabra PanaCast 50, PanaCast 50 -, PanaCast 50 - Black, PanaCast 50 - Grey, PanaCast 50 Room System, PanaCast 50 Room System MS (P50 AU charger & Lenovo ThinkSmart Kit), PanaCast 50 Room System ZR (P50 AU charger & Lenovo ThinkSmart Kit) Assembly Instructions

  • Hello, I've reviewed the user guide for the Jabra PanaCast 50 recessed wall mount. This document details the installation process, including wall preparation, bracket mounting, and tilt adjustment. I'm here to answer any questions you have about mounting your PanaCast 50 using this guide.
  • What is the minimum hole size in the wall?
    What size drill bit should be used for the wall?
    What should be done after attaching the camera to the bracket?
Recessed Wall Mount
for Jabra PanaCast 50
Wall bracket Mounting plate
Tilt lock Fisher wall plug
5/16 ” (8mm)
(4 pcs)
M5 x8
(2 pcs)
Disclaimer: Though products can be designed to meet the Americans with Disabilities Act (ADA) guidelines,
the United States federal government does not issue approvals or certify specific products as ADA-com-
pliant, nor does any other body. Jabra does not certify that this product is prima facie compliant with all
aspects of the ADA as the application, placement, and surroundings of the product within the space impact
accessibility and usability. However, following the instructions provided herein may allow the product to
comply with certain ADA standards in eect from time to time.
Cut a hole in the wall. The hole should be a minimum of 3 - 1/8” (8cm)
below the screen.
1
2
3
Mark the wall with drill holes and then drill into the wall using an
5/16” (8mm) drill bit.
Attach the wall bracket to the wall using the supplied screws.
6 - 3/16’’ (157mm)
Width
3 - 1/32”
(77mm)
Height
1 - 1/8”
(29mm )
Depth
7 - 5/16” (186mm)
Width
2 - 7/16”
(62mm)
Height
Φ 5/16” (8mm)
Remove the original mounting plate from the Jabra PanaCast 50.
The screws will be reused in Step 5.
Attach the tilt lock and new recessed mounting plate to the Jabra
PanaCast 50. Ensure that the tilt lock is in the unlocked position.
4
5
Plug in the necessary cables.
Attach the Jabra PanaCast 50 to the wall bracket.
If the Jabra PanaCast 50 is installed un-
derneath the screen, ensure the camera
is pointing straight ahead. Move the tilt
lock to the locked position to prevent
the camera from being able to tilt up
and down.
6
7
8
/