2. ALGE-Timing
  3. PB4

ALGE-Timing PB4 User guide

  • Hello, I'm a chat assistant that has read the user manual for ALGE-TIMING Photocell Boxes PB4 and PB4-H. This manual provides instructions on mounting, cable connections, and photocell installation. I'm ready to assist you with any questions you may have about these Photocell Box devices.
  • What size tube is needed for mounting the photocell box?
    How do you secure the holder to the tube?
    Where can the cables be passed through?
PB4
PB4-H
Manual
Version: D-12-04-01
Use a 5 cm round tube (pipe) to fasten the Photocell Box PB4 or PB4-H. The Photocell box
has a holder that fits for a 5 cm tube. You open the two screws on the Photocell Box and
screw the holder at the tube.
At the bottom of the Photocell Box are two leading out to get with the photocell cable and
power cable (if necessary) into the photocell case.
The photocell you screw into the box from the side (see picture below).
Holder
Screw 1 Screw 2
Tube
Leading out
for cables
Screw for
photocell PR1a
7,7
50
160
240
53
90
PB4H
290
Finish-Line
ALGE-TIMING GmbH
Rotkreuzstrasse 39
A-6890 Lustenau
Austria
Tel: +43-5577-85966
Fax: +43-5577-85966-4
[email protected]
www.alge-timing.com
/