2. Manson Engineering Industrial
  3. USB-2928

Manson Engineering Industrial USB-2928 Quick start guide

  • Hello! I've reviewed the Quick Start Guide for the Manson USB-2928 USB Power Station. This device features 8 USB ports, each capable of providing up to 2 amps, along with voltage and current meters, and a mAh recording function. It also has an intelligent sleep mode and a smart rolling display. I'm ready to answer your questions about this device and its features.
  • What is the maximum output current for each USB port?
    Can I use this power station outdoors?
    What is the purpose of the clear button?
    What are the general applications of this device?
    How do I clear the mAh record for all ports?
Quick
Start
Guide
USB-2928
8 Ports USB Power Station
For more information,
please visit our website:
http://www.manson.com.hk
1Precaution
•Use the USB power station indoor only
•Do not cover USB power station during use
•Do not use to charge damaged battery
•Voltage and Current meters are for reference only.
5Display and Indications
2Introduction
Manson USB-2928 8-port USB power station is a
smart power source for USB powered device.
General application;
•Charger for smart mobile device (iPad, iPhone,
Android device) with automatic optimization.
•Power source for DIY project,
such as Raspberry Pi, Arduino, and etc.
•Power source for mini-wifi station.
•Voltage and Current measure for USB device.
3Features
•8 x USB port, each port may provide Max 2 Amp
•Voltage and Current meter
•mAh record
•Intelligent sleep mode
•Smart rolling display, automatic skip no load port.
•Button to select port to display
•mAh clear button
4Electrical Specification
Input : 110/240Vac
Input Frequency : 50Hz/60Hz~
Output Voltage for each port : 5V ±0.2V
Max. Output Current for each port : 2Amp
V A
mAh
1 2
3 4
1. Output Voltage
2. Output Current
3. mAh Record
4. Port number
6Operation
i) Display switch – During USB station is ON, press Select
button to display information for next port.
ii) Clear mAh record for individual port – During USB station
is ON, press and hold Clear button until mAh become zero.
iii) Start/Stop display rolling – During USB station is ON,
press Select + Clear buttons together to toggle between
start and stop of display rolling.
iv) Clear current meter offset – During USB station is OFF,
disconnect all devices. Then press and hold both buttons
and power up.
v) Clear mAh record for ALL ports – During USB station is
OFF, press and hold Clear button during and power up.
7Power Saving Mode
•When all ports output current below 0.05A at the
same time for 1 minutes, the LCD panel will switch off.
•LCD wake up in 2 status
i) Output current of any port higher than 0.05A
ii) Press any button
/