RGB-DVI 300 and RGB-HDMI 300 (A) Setup Guide

CAUTION: Installation and service must be performed by authorized personnel only.

Unless otherwise stated, these instructions apply to both the RGB-DVI 300 and the RGB-HDMI 300 (A) video scalers and

converters. These instructions provide a quick setup guide for experienced installers.

Step 1 — Power Off

Turn all the equipment off and disconnect all cables.

Step 2 — Mounting

Mount the unit in a convenient location, in a rack, behind a display, under a desk, or through a desk.

Step 3 — Connect Video and Audio Input

flexibility.

A display is required to control the RGB-DVI 300 or RGB-HDMI 300 (A) using the menu and on-screen display.

Step 5 — Connect and Apply Power

Connect the 12 VDC external power supply (provided) to the 3.5 mm, two-pole, captive screw Power input connector. Apply

power to the RGB-DVI 300 or RGB-HDMI 300 (A) power supply. Then power on the display and power on the video source.

Step 6 — Configure System

Configure the system via the front panel controls and on-screen display, Simple Instruction Set

™

(SIS

™

) commands, or

the Signal Processing Products Control Program. (See the RGB-DVI 300 and RGB-HDMI 300 (A) User Guide for complete

instructions.)

RGB/ R-Y, Y, B-Y INPUT

60 Hz and 720p at 60 Hz, without needing the on-screen menu. Hold the Menu button while applying power

and the output rate is set to 1024 x 768 at 60 Hz during the first power on cycle. Hold the Menu button while

applying power a second time and the output rate will toggle to 720p at 60 Hz.

Front Panel Controls

Use the Menu and Enter Buttons and

two rotary encoders (shown in the

figure at right) to open and navigate

the menu, which is displayed on the

connected output display device. A

typical on-screen menu is shown in

into the menu. To move back one

level, press the Menu button.

For complete information about

configuring and controlling the unit

through the front panel controls

and the on-screen display, see the

RGB-DVI 300 and RGB-HDMI 300 (A)

User Guide, which is available online

at www.extron.com.

SIS Commands and Control Software

between the computer and the scaler.

For SIS control, the Extron DataViewer software can be downloaded

from the Extron Web site at www.extron.com. The control program can

also be downloaded from the Extron Web site.

For further information on controlling and configuring the scaler

through SIS commands or control program, see the RGB-DVI 300 and

RGB-HDMI 300 (A) User Guide, which is available online at

www.extron.com.