Hubbell Streetlight & Residential Lighting Foundation Installation guide

P303-0797

STREETLIGHT & RESIDENTIAL LIGHTING

FOUNDATION INSTALLING TOOLS

NOTE: Because Chance has a policy of continuous product improvement, we reserve the right to change design and speciﬁcations without notice.

These instructions do not claim to cover all details or variations in equipment, nor to provide for all possible conditions to be

met with concerning installation, operation, or maintenance of this equipment. If further information is desired or if particular

problems are encountered which are not sufﬁciently covered in this guide, contact A. B. Chance Company.

▲

! WARNING

Failure to monitor the condition of all parts and take corrective action as necessary may lead to failure during use, resulting

in personal injury or property damage.

Check all output string bolts along the drive train periodically to ensure they remain tight. Loose or damaged bolts may fail

at, or below the anchor’s torque rating or contribute to damage elsewhere in the output string. Check all parts periodically for

wear or damage and replace as necessary with original equipment. Replacement bolts must be the same grade and length as

the originals.

These instructions are intended to illustrate the use of these installing tools. Anchor installing tools covered in this instruction sheet

should be used by competent personnel familiar with and following good work and safety practices. Should additional information and

details be desired, or if speciﬁc situations arise which are not covered adequately for the user’s purpose, the speciﬁcs should be referred

to Chance. In some cases, Chance may make speciﬁc recommendations concerning installation torque and installed depth limits for

speciﬁc applications.

Attach the Kelly Bar Adapter to the Installing Tool using six 1/2-inch diameter grade 5 bolts provided. The axis of the kelly bar (output

shaft) should be concentric with the axis of the foundation before tightening the foundation drive bolts. Tighten drive bolts and follow

proper installation procedures furnished with the product. When a Kelly Bar Adapter with a threaded bolt circle is being used, Bolt Circle

Adapter C303-0115 must be mounted between either the Universal Installing Tool or Decorative Lighting Foundation Installing Tool and

the Kelly Bar Adapter. The T303-0247 drive plate attaches to Chance Decorative Lighting Foundations by using the 3/4-inch diameter

grade 5 bolts furnished with the foundation. The C303-0139 Universal Installing Tool is used to install Chance Streetlight Foundations

and Telephone Booth Foundation Anchors. C303-0139 attaches to the foundation base using the bolts provided with each foundation.

Be sure to align the tool so the holes in the tool line up with the proper bolt circle on the foundation.

RECOMMENDED TIGHTENING TORQUES

BOLT DRY TORQUE (ft.-lb.)

1/2" - Gr. 5 75

5/8" - Gr. 2 95

For proper installation procedures, follow the instructions that are included with streetlight and decorative lighting foundations.

KELLY BAR PISA™

WRENCH ADAPTER

DRIVE PLATE

(T303-0247)

(C303-0139)