Step 6:
Attach strike zone target (#3) to net using the hooks provided.
Step 7:
Assemble short target rod (#4) and insert into sleeve located at the
bottom of the strike zone target. There is a self-stick closure to keep
the pole in place.
Step 8:
Secure corners of the target net using the 4 metal ground stakes.
Franklin Sports, Inc.
Stoughton, MA 02072
www.franklinsports.com
For Replacement Parts, call
1-781-341-5178 or 1-800-225-8649
OR visit www.franklinsports.com
5
ALL-SPORT BACKSTOP
& PITCH TARGET
Item No. 19060
1
Phase 1
Adult assembly required
CAUTION:
ASSEMBLY INSTRUCTIONS
PARTS
Part
1
2
3
4
5
6
Amount
2
1
1
1
1
4
Description
Fiberglass Rod
All-Sport Net
Strike-Zone Target
Short Target Rod
Carry Bag
Ground Stakes
Replacement Part
19060Z1
19060Z2
........
........
........
19059Z5
Step 1:
Remove the large net (#2) and lay the item flat on the ground.
NOTE: Sleeves for poles should be facing up.
Step 2:
Assemble both support rods (#1) by inserting conjoining ends into
each other.
Step 3:
Insert one rod (#1) into corner opening of the net. Continue to insert
pole into sleeve until opposite end emerges out of the opposite corner.
Step 4:
Repeat Step 3 with the other support rod by inserting into the other
diagonal sleeve on the net.
Step 5:
At the ends of both pole sleeves is a pin attached by rings. Insert pin
into both ends of first fiberglass pole, and repeat for second pole.
NOTE: Pins will not go fully into the poles.
2
2 3
/
