Thinklogical HDMI Cable Retainers Installation guide

Installing HDMI Cable Retainers on TLX Extenders

Thinklogical HDMI Cable Retainers are designed to keep your video

cables installed securely in their devices. Easy to install, easy to

remove, it’s the logical solution.

Each Cable Retainer kit (KIT-000069-R) includes:

1 - M3 x 4mm Screw

1 - Cable Retainer Bracket

1 – Nylon tie-wrap

Step 1: Install the screw into the panel just above

the HDMI cable connector, leaving enough space

between the screw-head and the panel to allow

the bracket to slide between them.

Step 2: Install the HDMI cable into the connector.

Step 3: Install the Cable Retainer Bracket by sliding it over the screw

and against the panel until it is fully seated above the cable.

Tighten the screw.

Step 4 (optional): Install a Nylon tie-wrap as shown.

Download PDF