Baja SC50 Installation guide

Brand: Baja

Model: SC50

Type: Installation guide

1. Removecardboardcarton

from metal frame.

2. Removewire strapsand foam

covering from handlebars.

3. Remove boltsholding metal

frame to rear of scooter.

4. Remove axle bolt holding metal

frame to front forks.

5. Removemetalframe and parts

includedfor assembly.

QTY1

QTY4

Frontfender Frontwheel

Frontwheelspacer

QTY1

Partslistedbelowfoundunderseat

Mirrors

ManufacturerCertificate

of Origin

OwnersManual

Floorboardcover/mat

Plasticvin cover

ToolKit Battery Box

Axle bolt

Alignmentgroove

on frontfork

Speedsensor

Alignspeedsensorbetween

front wheeland front fork.

Alignmenttab on

speedsensor

Frontwheel

spacer

Placefront wheel spacerbetweendisc

brakeandfork onaxle bolt.Attachfront

wheelwithaxle boltprovided.

Torqueto 33ft.lbs.

Spacer

Removebrakecaliperspacer

beforeattachingbrakecaliperto

front wheel usingboltsprovided.

Handlebar stem

9. Attach handlebar assembly to

stem using bolt provided.

Nut

Bolt

Nut

10. Attach front fender. Lineuptabsof fender

withslotsonscooter.Securewithfour philliphead

screwsand one phillipheadboltandwasher.

11. Attach leftand rightmirrors

to handlebars.

Battery located in

floorboard under mat.

12. Refer to battery section of

owners manual for correctinstallation

and chargingof battery.

The following procedureis very dangerousand should be performedwith utmostcare and attention. Wear

protective eyewear,rubber gloves,and havewater availableshould electrolyte come in contactwith skin or

eyes. KEEPALL CHILDRENAWAYFROM THEAREAWHILE THIS PROCEDUREIS BEING PERFORMED.

POISON - CAUSES SEVERE BURNS

Contains sulfuric acid.

Avoid contactwith skin, eyes, or clothing

Toprevent accidents, rinse empty container with water.

ANTIDOTE:

External- flush with water

Internal- Call physicianimmediately.Drink large quantities of water ormilk.

Followwith milk of magnesia, beateneggs or vegetable.

Eyes- Flushwith water for 15minutes and get promptmedicalattention.

KEEPOUT OF REACH OF CHILDREN.

Note:The followingpageisforvehicleswith battery'scontainingseparateelectrolytepack.Most

battery'swill comewith theelectrolytealreadysealedintothe battery.

Preparingthe battery:

Placebatteryonlevelsurface.Removesealingtape

from top.(seefigure20)

Takethe electrolytecontainerout ofthe plasticbag.

Placeelectrolytecontainerupsidedownwiththe

sealedsilvermouthsof theelectrolytebottlesinline

withthesix fillerholesof the battery.(seefigure21)

Pushthe containerdownstronglyenoughto breakthe

silverseals.

As electrolytestartsflowinginto battery,air bubbles

will comeupfrom themouthsof the plasticelectrolyte

bottles.

Leavebottlesupsidedownin batteryholesuntil

electrolyteiscompletelydrained.

Neverleavechildrenunattendedaroundbattery.

If air bubblesceaseto float to the topof theelectrolyte

bottles,tap lightlyontop.

DO NOTremovecontainerfrom batterywhile it is

draining.

Nevercutor pierceelectrolytecontainer.

Afterall theelectrolytehasdrainedfrom the bottles

intothe battery,pullplasticelectrolytebottlesgently

outof the battery.

Discardemptyelectrolytebottlesinawaste areathat

is inaccessibleto childrenand animals.

Afterfillinglet batterystandfor at least30 minutes

beforecharging.Thisallowsthe electrolyteto

penetrateplatesfor optimumperformanceand ensures

longerbatterylife.

After30 minutesthe batteryis readyfor its initial

charge.Placecapstriplooselyoverthe fillingholesas

showninthe picture.(seefigure22)

Figure20

Figure21

Figure22

Howto InitiallyChargethe battery:

1. Connectthe redpositive(+) cableto the redpositive(+)

poleof thebattery.

(seefigure23)

2. Connectthe blacknegative(-) cableto the black

negative(-) poleof the battery.(seefigure24)

Note:The red positive(+)cablehasa largerdiameter

thanthe blacknegative(-) cable.

Chargingrate:Chargebattery@0.7Amps for

5 ~ 10 hours.

• Afterchargingiscomplete,pressdownfirmlywith

bothhandsto seatthe caps.(Do not poundor

hammer.)The batteryisnowsealed.(seefigure25)

• Locatebatterycompartmentonscooter. The

batterycompartmentis locatedunderthefloorboard.

(seefigure26)

• Attachredpositive(+)cableto positive(+)terminal

on battery. Thenattachblacknegative(-)cableto

negative(-)terminalon battery.

Figure23

Figure24

NEVERREMOVETHESTRIPOFCAPS

NORADDANYWATEROR ELECTROLYTE.

Figure25

Figure26

13. Fill engine with correct amount of oil. Refer

to owners manual for oil typesand quantity.

14. Fillgastankasspecifiedinownersmanual. I

Oil Plug.

15. Referto ownersmanualfor proper

startinginstructions.

ATTENTION:Side kickstandmustbeplaced

in uprightpositionin orderto startengine.

!!WARNING!!

Thisenginemaybeshippedwith packingoil

in it.Thisoil shouldbe drainedand replaced

with new oilas describedintheowners

manual.Neverattemptto startenginewith-

outfirstreplacingthe engineoilwiththe

properamountand gradeas describedin

theownersmanual.

Baja SC50 Installation guide

Baja SC50 Installation guide

Baja SC50 Installation guide

Related papers

Other documents