Firepower Firepower Basic Utility Cart Troubleshooting instruction

Brand
Firepower
Model
Firepower Basic Utility Cart
Type
Troubleshooting instruction

This manual is also suitable for

Firepower BASiC UTiLiTY CArT ASSeMBLY inSTrUCTionS
0-5368, Rev. AA 1 December, 2014
!
WARNING
Maximum Gas Cylinder 9" (230mm) Diam-
eter.
!
WARNING
Do Not Lift Cart with Power Source, Gas
Cylinder or any other equipment attached.
NOTE
Power Source MUST be mounted onto base
assembly before mounting wire feeder to
handle assembly.
!
WARNING
Do Not Exceed a maximum weight of 110 lb
(50 kg) on the top shelf of the base assembly.
Do Not Exceed a maximum weight of 88 lb
(40 kg) on the bottom shelf.
CAUTION
Do Not Exceed the Cart total load capacity of
298 lb (135 kg).
Manual 0-5368
Rev AA
Firepower Basic Utility Cart
Part Number: 1444-0900
Assembly Instructions
© 2014 by Firepower
General Information
The Firepower Basic Utility Cart is designed for most
Welders and Cutters. It allows easy transportation for the
power source, gas cylinder, welding torch and various
accessories. These instructions will guide you through
the proper assembly procedure of the cart.
Recommended Tools
• MetricHexKeySize4and6
• OpenEndWrenchMetric19mm-22mmor8”
Adjustable Wrench
• Pliers
Firepower
Suite300,16052SwingleyRidgeRoad,
St.Louis,MO63017,USA
TechnicalService:1-800-426-1888FAX:1-800-535-0557
Customer Service: 1-800-858-4232
FirepowerOnline.com
Firepower BASiC UTiLiTY CArT ASSeMBLY inSTrUCTionS
December, 2014 2 0-5368, Rev. AA
Supplied Parts
The following components are included in this kit:
Item Description Qty
1 CHAIN,.16"x1.36"x28" 2
2 HANDLE 1
3 SIDEBRACKET 2
4 NUT, M12 2
5
SCREW,M6X16mm
TORQUEFORCE:14-17ftlb(19-23N.m)
2
6 BASE ASSEMBLY 1
7 CASTER 2
8 AXLE 1
9 WHEEL 2
10 COTTERPIN 4
11 PLAINWASHER 4
12 HOOK 2
1
2
3
6
4
7
8
12
10
11
9
5
Art # A-12747
10
11
Firepower BASiC UTiLiTY CArT ASSeMBLY inSTrUCTionS
0-5368, Rev. AA 3 December, 2014
A. Insert Axle
Insert the axle (8) through the holes in the bottom of
thebaseassembly(6).
8
6
Art # A-12748
B. Install Wheels on Axle
1. Attach a plain washer (11) to the axle.
2. Slide a wheel (9) over the axle followed by a washer
(11) as shown.
9
11
Art # A-12749
C. Attach Wheels
1. Insert a cotter pin (10) through the hole in the axle
from the top down as shown.
2. Spread the cotter pin apart by using a pair of pliers.
3. RepeatstepsBandCwiththeotherwheel.
10
Art # A-12750
D. Install Casters
1. Insertacaster(7)throughtheholeinthebottomof
the base assembly.
2. Fasten the caster using the caster nut (4) as shown.
3. Install the other caster following steps 1 and 2.
Art # A-12751
7
4
E. Attach Handle Assembly
1. Attach handle assembly (2) to base assembly and
line up its 2 holes with the 2 holes in the base assembly.
2. Fasten the handle assembly using hooks (12) and
cotter pins (10) as shown.
3. Spread the cotter pin apart by using a pair of pliers.
2
12
Art # A-12752
10
F. Install Side Brackets
1. Insert the side brackets (3) into the two slots on the
top of the base assembly.
2. Use the screws (5) to fasten the brackets as shown.
A slots are designed for the MST220i
B slots are designed for the MST180i, MST140i
5
5
3
3
Art # A-12753
A Slots
B Slots
G. Tighten All Hardware
Fully tighten all the fasteners at this time but do not over-
tighten.Refertotorqueforceinsuppliedpartssection.
H. Hang Chain
1. Insert one end of the Chain (1) through the chain
holeontheleftsideoftheHandleAssemblyandsecure
it by turning and sliding the second link into the slot (top
hole as shown).
2. Wrap the chain around the upper part of the Gas
Cylinder and pull the other end through the chain hole
ontherightsideoftheHandleAssembly.
3. Pull the chain as tight as it will go and secure it by
turning and sliding the closest link into the slot.
4. Wrap and secure the other chain around the lower
part of the gas cylinder following steps 1 to 3.
Art # A-12754
1
© 2014 Victor Technologies International, Inc. FirepowerOnline.com
Customer Service: 1-800-858-4232 •Technical Service: 1-800-426-1888 •FAX: 1-800-535-0557
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

Firepower Firepower Basic Utility Cart Troubleshooting instruction

Brand
Firepower
Model
Firepower Basic Utility Cart
Type
Troubleshooting instruction
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents