2. Zebra
  3. ST3113

Zebra ST3113 Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Zebra ST3113 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
The Vehicle Power Outlet Adaptor allows you to power your hand-held and recharge your battery using power drawn from your vehicle’s
automotive power outlet when used in conjunction with a Snap Module.
1. Attach a Snap Module to the base of the hand-held.
2. Insert the DC power plug on the Vehicle Power Outlet Adaptor into the DC IN port on the Snap Module.
3. Insert the Vehicle Power Outlet Adaptor plug into the automotive power outlet in your vehicle.
Installation — Chargers and Docking Stations
When installing a charger or docking station, consider the following guidelines:
1. Keep chargers and docking stations away from excessive dirt, dust, water and other liquids, and contaminants.
2. Chargers will not charge batteries outside an ambient temperature range of 0°C to 40°C (32°F to 104°F). It is recommended that the
charger or docking station be operated at room temperature — between 18°C and 25°C (64°F to 77°F) for maximum performance.
After unpacking your unit:
1. Visually inspect the charger for possible damage.
2. Install the IEC power cord (if applicable) and apply power.
Operator Controls
The Omnii docking stations and chargers have no operator controls.
Power Consumption Considerations
Check to ensure the mains circuit supplying chargers and/or docking stations is adequate for the load, especially if several chargers and
docking stations are being powered from the same circuit.
NOTE Battery charging continues whether the hand-held is switched on or off.
Adaptor Plug
DC Power Plug
VEHICLE POWER OUTLET ADAPTOR - ST3113
INSTRUCTION SHEET
Service Information
If you have a problem using the equipment, contact your facility’s Technical or Systems Support. If there is a problem with the equipment, they will contact
the Global Support Center at: http://www.zebra.com/support
.
For the latest version of this guide go to: http://www.zebra.com/support
.
Zebra Technologies Corporation
Lincolnshire, IL U.S.A.
http://www.zebra.com
Zebra and the Zebra head graphic are registered trademarks of ZIH Corp. The Symbol logo is a registered trademark of Symbol Technologies, Inc., a Zebra Technologies company.
© 2014 Symbol Technologies, Inc.
MN001621A02 Revision A — April 2015
/