MoTrade LEXUS RX450 User manual

Brand: MoTrade

Model: LEXUS RX450

Type: User manual

Motrade December 2023 ©

Installation instruction for Carplay Android Auto interface

LEXUS RX450 201 0-2012 with mouse control

The interface is connected to the radio and the display. It is

estimated that it takes 45-60 minutes of work to connect the interface. No

programming is necessary.

Step 1. Remove the rear seat cover panel (unclip)

Click the center console cover panel off. Unplug the connector on the unit and

connect it to the contra connector of the Vline connection cable.

Step 2. Remove the display (unclip)

Pull out the bezel of the display. Start in the lower right corner and work carefully

towards the remaining corners.

Motrade December 2023 ©

Pull out the video plug and connect it to the contrast plug of the Vline's video cable.

Reconnect the video connector to the display. Unscrew the display (3 screws) and

put it in a safe place.

Step 3. Remove the center panel (pull up)

Remove the center panel by unclipping it on the side of the storage compartment

and pulling it up. Unscrew the gear lever knob to remove the panel. Pull out the 5

connectors and place the panel in a safe place.

Motrade December 2023 ©

Step 4. Remove the edge of the center armrest (pull off)

Unplug the edge and remove the three screws from the side panel.

Step 5. Drill a hole for cable transit

Remove the storage compartment in the center console, underneath is a large space

for placing the Vline. Drill a hole for cable pass-through. Make sure that the hole is in

a place where the cables are not an obstacle to the center console.

Motrade December 2023 ©

Step 6. Pull the cables to the storage compartment

Route the cable from the back of the center console through the inside of the side

panel to the transit hole. Route the video cable and microphone cable behind the

radio to the transit hole. The radio can stay in place using a pull cable.

Step 7. Connect the plugs to the interface

Make sure that the video cable does not kink at the connection point on the interface.

Step 8. Test the system

Connect the interface. Choose USB or HDD-AUX to switch from the radio to the Vline.

Remove and forget the existing bluetooth connection to the car.

Connect the phone to the bluetooth signal of the interface and turn on WIFI.

Test the system with respect to graphics, sound, scchopping between radio and

interface and backwards.

Step 9. Reconnect the system

Reconnect all components in reverse order. For example, place the microphone in

the indicated position.

Motrade December 2023 ©

Step 10. Have fun!

This manual has been compiled on the basis of experience and with the necessary

care. No rights can be derived from it. Improvement tips/tricks are of course always

welcome! ([email protected])

1
2
3
4
5

MoTrade LEXUS RX450 User manual

Brand: MoTrade

Model: LEXUS RX450

Type: User manual

Download PDF

Related papers

Other documents