2. Garth
  3. Fascia Set Replacement
Fascia Set Replacement

Garth Fascia Set Replacement Operating instructions

  • Hello! I have reviewed the user manual for replacing the fascia set. The manual provides detailed instructions with specific steps, from disconnecting the ignition wire to removing the replacement panel. I'm ready to assist you with any questions you may have regarding this process.
  • What is the first step to replace the fascia set?
    What should you do after pulling out the ignition wire?
    What is the final step to replace the fascia set?
How to replace the fascia set
Step 1: Pull out the side burner ignition wire.
Step 2: Take out the bolt from the side burner injector bracket.
Step 3: Take out the three bolts shown on either side of the side burner shelf.
Step 4: Loosen the front fixing screws 3mm as shown below on either side of the
side burner shelf.
Step 5: Fold open the right-side furnace
Step 6: Take out the three screws as shown below on the left side shelf.
Step 7: Loosen the front fixing screws 3mm on the left side shelf as shown below.
Step 8: Fold open the left side table
Step 9: Loosen the two set screws in the sides of the panel。
Step 10: Take out all the knobs.
Step 11: Remove all screws from the knob bezel.
Step 12: Remove the replacement panel。
/