91781

Endon 91781 User manual

  • Hello! I'm a chat assistant, and I've read the instruction manual for the floor light. This document covers important safety information, step-by-step assembly instructions, and how to correctly operate the device. I am ready to answer your questions about the product.
  • Is this light suitable for bathroom use?
    Can I cover this lamp while it's in use?
    How should I clean this product?
Safety Warnings
INSTRUCTION MANUAL
This product is only suitable for connection to a 220-240V~50Hz supply. It is for indoor use only, and not suitable
for a bathroom location.
connected to Earth.
Under no circumstances must this lamp be covered with any material as this could pose a safety hazard.
Allow 10 minutes to cool before replacing, adjusting or cleaning.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
This product may contain delicate parts – be careful during handling and maintenance to avoid breakage.
Assembly/ User Instructions
Before you start
that you have all the required parts. Follow each assembly step in order to prevent incorrect assembly. Ensure that
the product is fully assembled as illustrated before use.
These assembly diagrams are intended as a guide – if in doubt
1. Do not attempt to plug in or use this product until it has been fully
assembled. Disconnect from mains during assembly or maintenance.
2. Carefully remove all packaging from the base section, central tubes
3. Screw the tube A onto Tube B in a clockwise direction. Take care not to
trap the cable or cross the thread. Then screw Tube B on to Tube C in
the same way.
4. Gently pull any excess cable through from under the base and then
out through the side of the base. Screw the base onto the assembled
stems, turning in clockwise., Ensure that the cable will straighten when
the tubes are fully assembled.
5.
tube by hand.
6. Stand the product upright and check the tightness of the joints by hand.
7. Fit the bulb.
8. Plug in, and operate the foot switch to turn your lamp on.
Tube A
Tube B
Tube C
Foot switch
Base
1
2
3
4
5
Floor Light
To use this item in Europe, the 3 pin adaptor can be removed by
loosening the central screw and removing the adaptor to reveal
the 2 pin Europe plug.
Converting 3 pin to 2 pin plug
1
BS 5733
2
BS 5733
3
BS 5733
91781_91934_91937-98095-11102021 EU Manufacturer: 1 Gnarrenburg, 27442
UK Manufacturer: BH17 7BY
/