1
Installation Instructions for
Matrimonio 1 Light Pendant
1.1
P1394-P1395
Pendant
P1394, P1395_
Determine the wanted height of the fixture by feeding the cord through the canopy and moving the cord up or down.
Place the cord in between the two cord clips and secure it in place using the clip screws.
Trim the cord leaving enough for electrical connections. From the end of the cord, strip the insulation 4” and then strip the
end of the wires. Note: Make sure not to nick the inner wires.
Place the shade onto the socket and secure it in place by screwing the collar nut onto the socket.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.
1
2
1A
LAMP
SHADE
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
CANOPY
CORD CLIP
CLIP SCREW
3
4
5
5
6
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant
junction boxes.
This product is safety listed for dry locations only.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
2
CORD
6
4