Generation Lighting OL7411ASTB Installation guide

Type
Installation guide

This manual is also suitable for

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly.
Bulbs not included.
1. This fixture can be mounted onto ceiling either as stem
hung or semi flush mount:
STEM HUNG INSTALLATION- Fig. 1:
A. Choose desired installation height from dimensions
shown in above diagram. Thread fixture wires through
each stems to be used. Note correct position of stems
from left diagram. Screw all stem together until secure.
B. Install bottom end of stem assembly by screwing on
top of fixture.
C. Pass fixture wire through swivel in canopy and screw
top end of stem assembly onto swivel.
SEMI FLUSH INSTALLATION-Fig. 2:
A. Remove and discard swivel.
B. Threaded fixture wires through canopy, lock washer,
and hex nut. Lock all together on top of fixture by
tightening hex nut.
2. Follow enclosed supplement installation instructions
for electrical and fixture installation onto house outlet
box. If you do not have an outlet box at desired
location to attach the fixture than hire a qualified
electrician to create one.
3. Lift latch to open door.
4. A. Slip candle tube over socket.
B. Install candle follower over candle tube.
C. Install type-B, candelabra base, of 60 Watt maximum
bulbs (not included).
5. Close door.
Assembly Instructions For
OL7411
(E) 5/09
4C
4B
4A
1C
1A
1A
1B
1B
3
2
5
SEMI FLUSH MOUNT
FIG.2
FIG.1
48-1/2"
29"
36-1/2"
42-1/2"
60-1/2"
66-1/2"
78-1/2"
72-1/2"
84-1/2"
54-1/2"
  • Page 1 1

Generation Lighting OL7411ASTB Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI