Generation Lighting F2403EN3/3BS Installation guide

Brand
Generation Lighting
Model
F2403EN3/3BS
Type
Installation guide
Assembly Instructions For
F2403/3
(E) 12/08
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulb not
included.
1. Install stems:
A. Choose desired installation height from dimensions shown in
above diagram. Thread fixture wires through each stems to be
used. Note correct position of stems from left diagram. Screw all
stem together until secure.
B. Install bottom end of stem assembly by screwing into top of
fixture.
C. Thread fixture wires through canopy, plastic ring and then
swivel. Allow canopy to carefully slide down without scraping the
surface of stems. Then install swivel by screwing onto top end of
stem assembly.
2. Follow enclosed supplement installation instructions for electrical
and fixture installation onto house outlet box. If you do not have
an outlet box at desired location to attach the fixture than hire a
qualified electrician to create one.
3. Install glass shade onto fitters by fastening with spacer ring (open
side facing up) and counter ring onto threaded sockets.
4. Install bulb (not included). See relamping label located near
socket area for type and maximum allowed wattage.
Bulb
(not included)
Stems
Shade
Canopy
(Fixture Plate)
Plastic Ring
Swivel
Counter Ring
Spacer Ring
Fixture Wires
Socket
4
2
1
3
12-3/4"
30-3/4"
18-3/4"
24-3/4"
48-3/4"
42-3/4"
36-3/4"
54-3/4"
60-3/4"
  • Page 1 1

Generation Lighting F2403EN3/3BS Installation guide

Brand
Generation Lighting
Model
F2403EN3/3BS
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents