2. Neutrik
  3. NC3FDX-TOP

Neutrik NC3FDX-TOP Operating instructions

  • Hello! I have reviewed the assembly instructions for the Neutrik XLR Chassis TOP, specifically models NC*FDX-TOP SCFDX-TOP and NC*MDX-TOP SCMDX-TOP. This document details the correct steps for installation, including attention to tightening torque, proper lubrication, and the use of specific screws. I'm ready to answer your questions about this product and the assembly process.
  • What is the recommended tightening torque?
    What type of screws should be used?
    What should be done with O-Gasket?
ASSEMBLY INSTRUCTION
R
XLR Chassis TOP NC*FDX-TOP with SCFDX-TOP
NC*MDX-TOP with SCMDX-TOP
E / Panelquipment
ATTENTION:
Tightening torque
MA= 40 Ncm
Find more details of
XLR Chassis on
www.neutrik.com.
Ø 23.8 [.937] - 24.2 [.953]
19.0 [.748 ]
±0.1 ±0.003
≥Ø 3.2 [.126]
24.0 [.945 ]
±0.1 ±0.003
C
Insert the ribbon through
the dedicated slot.
(1) Split the ribbon and
(2) put through the cover.
Tighten the ribbon
1Connector installation
2Mount the sealing cover
3Panel Cutout (Rear Side)
Any TOP XLR
chassis connector
4x
Screws
1
Lubricate O-Gasket
with silicon on all
4 screw holes.
2
4Recommended screw
5.3 - 6.0
[.201 - 0.236”]
90°
Draft. Nr.: BDA 553 Update: . .20113 09 8
II
www.neutrik.com
Neutrik AG LI T: +423 / 237 24 24 F: +423 232 53 93/
Neutrik USA Inc. USA T: +1 704 / 972 3050 F: +1 704 438 9202/
Neutrik ()
UK Ltd. UK T: +44 1983 / 811441 F: +44 1983 811 439/
Neutrik Vertriebs GmbH DE/NL/AT/DK T: +49 8131 / 280 890 F: +49 8131 280 830/
Neutrik France FR T: +33 1 4131 6750 F: +33 1 4131 0511//
Neutrik Tokyo Ltd. JP T: +81 3 3663 4733 F: +81 3 3663 4796//
Neutrik Hong Kong Ltd. HK T: +852 2687 6055 F: +852 2687 6052//
Neutrik India Pvt. Ltd. IND T: + F: +91 22 26163 54091/ 982 05 43 424 /
R
Data subject to change without prior notice. 201 NEUTRIK ALL RIGHTS RESERVED8 . NEUTRIK are registered trademark of NEUTRIK AG. .©®®
M3 stainless steel
countersunk type
IP65 RATED AND UL50E APPROVED.
/