2. AGI
  3. Manual Belt Engage

AGI Manual Belt Engage Installation guide

  • Hello! I've reviewed the installation instructions for the A451, A452, A453, A454, and A455 manual belt engage systems for STX2 and XTA series augers. I understand the assembly process, including guard installation, engine pulley guard installation, and belt tensioning. I'm ready to answer your questions about these procedures and components.
  • What are the applicable models for this manual?
    What is the purpose of the hex nuts in the assembly?
    What should I do after tensioning the belt?
31093 R0
Revised: APRIL 2020 1
A451/A452/A453/A454/A455
Manual Belt Engage
Installation Instructions
Applicable Models:
STX2 & XTA Series
Install the Guard Assembly
31' Augers
1Guard Assembly 3Locknut, 3/8"
2Bolt, 3/8" x 1"
1
2
1
3
2 31093 R0
36'/41'/46'/51' Augers
1Bottom Guard Assembly 3Locknut, 1/2"
2Bolt, 1/2" x 1–3/4"
3
1
2
A451/A452/A453/A454/A455 – MANUAL BELT ENGAGE
31093 R0 3
Install the Engine Pulley Guard
Assembly Note:
• Slip guard over the engine pulley and slide into the guard assembly.
1Guard 7Locknut, 3/8"
2Manual Belt Engage Handle Assembly 8Bolt, 1/2" x 1–3/4"
3Manual Belt Engage Mount Bracket 9Locknut, 1/2"
4Manual Belt Engage Threaded Rod 10 Bolt, 1/2" x 1–1/2"
5Manual Belt Engage Guide Rod 11 Bolt, 1/2" x 1–1/4"
6Bolt, 3/8" x 1" 12 Hex Nut, 5/8"
2
9
9
4
11
10
124
3
1
5
8
7
9
3
6
5
6
A451/A452/A453/A454/A455 – MANUAL BELT ENGAGE
4 31093 R0
Tension the Belt
1
TIGHTEN BELT
LOOSEN BELT
Assembly Note:
• Use the two hex nuts to apply tension to the drive belt prior to closing the guard cover.
• Close the guard using the rubber draw latches after the belt has been tensioned.
1Hex Nut, 5/8"
P.O. Box 39
Rosenort, Manitoba, R0G 1W0 Canada Website: www.grainaugers.com
Phone: (866) 467-7207 (Canada & USA) or (204) 746–2396 Email: [email protected]
Fax: (866) 768-4852 ©Ag Growth International Inc. 2020, Printed in Canada
A451/A452/A453/A454/A455 – MANUAL BELT ENGAGE
/