Page is loading ...
INSTALLATION
GUIDE
HOME
SMART
ELDERLY
CARE
HOMEKIT
What’s in the box?
×1
Gateway
×1
Temperature &
Humidity Sensor
×2
Door Sensor
×4
Motion Sensor
×1
Network Cable
For gateway
×1
Transmitter
For bedpad
×1
Bed Pad
×24
Velcro Pads
For gateway & sensors
×2
Double-Size Magnet
For door sensor
×1
Power Plug
For gateway
How to Install
1
Gateway
Connect network Cable
Connect power Cable
Network
Power
Button
RF Signal
Power cable
Reset
Network cable
2
Bed Pad
Cover bed pad with a bed sheet
Transmitter cable ON / OFF Switch
Plug transmitter into connector inside bed pad side pocket
Switch on transmitter and ensure red light flashes
Cover transmitter inside side pocket
Press and hold bed pad for at least 15 seconds to
activate transmitter
Place bed pad on a mattress at shoulder or hip level
3
Temperature & Humidity Sensor
Slide to open battery cover
Insert 2 AAA batteries
Temperature & humidity sensor should be installed
at a well-ventilated indoor location
Velcro pad
AAA batteries ×2
Wall mount hole
Wall
Wall
4
Motion Sensor
Slide to open battery cover
Insert 2 AAA batteries
Install motion sensors in living room, kitchen, bathroom
and toilet to cover the areas where most daily
activities occur.
Velcro pad
AAA batteries ×2
Wall mount
hole
Wall
Wall
5
Door Sensor
Slide to open battery cover
Insert 2 AAA batteries
Install the main part of sensor at the opening side
of the door
Install the small part on the door frame closely to the
main part with less than 1cm distance
AAA batteries ×2
Velcro pad
Double-sized magnet can be used to line up
with the main sensor.
Or
Door Frame
Door
(Inside)
Door Frame
Door
(Inside)
Max Distance<1cm
1
Where to put
Gateway
Near the Internet port
2
4 Motion Sensor
In the living room
In the kitchen
In the toilet
In the bathroom
3
2 Door Sensor
At the main door
At the back door
4
Temperature &
Humidity Sensor
Temperature & humidity
sensor should be installed at a
well-ventilated indoor location
5
Bed Pad
On the bed
Gateway Reset
Reset
Please follow below steps to reset the gateway if your
App account does not connect.
1
Ensure Internet and power cable is connected to
gateway
2
Use the end of a paperclip to press the reset button
at the back of gateway
3
Press and hold for 5 second to reset the internet and
account setting
4
Reconnect Internet and power cable after the
indication light stops flashing
Now, you can retry the normal setup procedures with
an existing or new App account.
/