Barco DICOM Theater Lite User manual

Installation & User Manual

MGP D5 Dicom Theater Lite

Copyright notice

MGP D5 Dicom Theater Lite 3

Copyright notice

This document is copyrighted. All rights are reserved. Nor this

document, nor any part of it, may be reproduced or copied in any

form or by any means - graphical, electronic, or mechanical

including photocopying, taping or information storage and

retrieval systems - without written permission of Barco

Copyright notice

4 MGP D5 Dicom Theater Lite

(This page intentionally left blank.)

Table of Contents

MGP D5 Dicom Theater Lite 5

Table of Contents

Preface........................................................................................ 7

Safety Instructions............................................................................. 11

Explanation of symbols..................................................................... 14

Overview...................................................................................15

Introduction ....................................................................................... 17

About the system....................................................................... 17

About the separate components............................................... 17

Other relevant documentation.................................................. 18

Important installation considerations ....................................... 18

Minimum system requirements................................................ 18

Quick installation overview .............................................................. 19

MGP D5 Dicom Theater installation overview .......................... 19

Installation examples................................................................. 19

Display Controller Installation ..................................................27

BarcoMed 2MP2CP Overview............................................................ 29

Display controller installation ........................................................... 31

Display Controller Software Installation .................................. 35

Windows 2000 BarcoMed 2MP2CP software installation ............... 37

Display Controller Tools ............................................................ 47

Barco Display Tab............................................................................... 49

Introduction ................................................................................ 49

Using the Barco Display Tab ...................................................... 50

BarcoMed Driver Tab ......................................................................... 52

Introduction ................................................................................ 52

Using the BarcoMed Driver Tab ................................................. 52

Status .......................................................................................... 53

Monitor Configuration ................................................................ 54

BarcoMed Hardware Tab ................................................................... 55

Table of Contents

6 MGP D5 Dicom Theater Lite

Introduction ................................................................................ 55

Using The BarcoMed Hardware Tab........................................... 56

Display Tools.............................................................................63

Barco DPMS Screen Saver ................................................................. 65

Introduction ................................................................................ 65

Barco DPMS Screen Saver Options............................................. 65

Getting started with the Barco DPMS Screen Saver................. 68

Using the Barco DPMS Screen Saver ......................................... 69

Installing or Reinstalling Barco DPMS ....................................... 73

Uninstalling Barco DPMS............................................................ 73

MediCal Pro Software ...............................................................75

MediCal Pro installation .................................................................... 77

Using MediCal Pro.............................................................................. 78

TheaterWatch Software ............................................................79

TheaterWatch Installation ................................................................. 81

Using TheaterWatch........................................................................... 83

Introduction ................................................................................ 83

Display settings .......................................................................... 85

Test patterns............................................................................... 95

Application settings.................................................................... 96

Update TheaterWatch................................................................. 99

Troubleshooting......................................................................101

Windows 2000 display resolution ........................................... 103

Driver re-installation, updates or removal..................................... 105

Reinstalling or updating your BarcoMed 2MP2CP driver ....... 105

Uninstalling the BarcoMed 2MP2CP driver ............................. 106

Warranty Statement ...............................................................111

MGP D5 Dicom Theater Lite 7

Preface

(This page intentionally left blank.)

8 MGP D5 Dicom Theater Lite

(This page intentionally left blank.)

Preface

MGP D5 Dicom Theater Lite 9

Notice

Although every attempt has been made to achieve technical

accuracy in this document, we assume no responsibility for errors

that may be found. Our goal is to provide you with the most

accurate and usable documentation possible; if you discover

errors, please let us know.

BarcoView software products are the property of BarcoView.

They are distributed under copyright by Barco N.V. or BarcoView,

LLC., for use only under the specific terms of a software license

agreement between Barco N.V. or BarcoView LLC. and the

licensee. No other use, duplication, or disclosure of a BarcoView

software product, in any form, is authorized.

The specifications of BarcoView products are subject to change

without notice.

Trademarks

All trademarks and registered trademarks are property of their

respective owners.

FCC notice

This equipment has been tested and found to comply with the

limits of a Class A digital device, pursuant to Part 15 of the FCC

rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in

a commercial environment. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and used

in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the

interference at his own expense.

Preface

10 MGP D5 Dicom Theater Lite

Canadian notice

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la Classe A est conforme à la norme

NMB-003 du Canada.

Safety Instructions

MGP D5 Dicom Theater Lite 11

Safety Instructions

General Recommendations

Read the safety and operating instructions before operating the

display.

Retain safety and operating instructions for future reference.

Adhere to all warnings on the display and in the operating

instructions manual.

Follow all instructions for operation and use.

Electrical shock

Type of protection (electrical):

Class I equipment

Degree of safety (flammable anesthetic mixture):

Equipment not suitable for use in the presence of a flammable

anesthetic mixture with air or with oxygen or nitrous oxide.

Power connection

• Power requirements: The display must be powered using the

12 VDC power supply that is supplied with the display.

• The 12 VDC power supply must be powered by the AC mains

voltage.

Safety Instructions

12 MGP D5 Dicom Theater Lite

•Power cords:

Power cord with CEE 7 plug: The colors of the mains

lead are colored in accordance with the following

code: Green-and-yellow: Earth (safety earth), Blue:

Neutral, Brown: Line

Power cord with ANSI 73.11 plug: The wires of the

power cord are colored in accordance with the

following code: Green/yellow: ground, White:

neutral, Black: line (live)

• Do not overload wall outlets and extension cords as this may

result in fire or electric shock.

• Mains lead protection (U.S.: Power cord): Power cords should

be routed so that they are not likely to be walked upon or

pinched by items placed upon or against them, paying

particular attention to cords at plugs and receptacles.

Water and moisture

Never expose the display to rain or moisture.

Never use the display near water - e.g. near a bathtub,

washbasin, swimming pool, kitchen sink, laundry tub or in a wet

basement.

Ventilation

Do not cover or block the ventilation openings in the cover of the

set. When installing the display in a cupboard or another closed

location, heed the necessary space between the set and the

sides of the cupboard.

Installation

Place the display on a flat, solid and stable surface that can bear

the weight of at least 3 displays. If you use an unstable cart or

stand, the display may fall, causing serious injury to a child or

adult, and serious damage to the equipment.

More warnings in the Installation chapter.

Safety Instructions

MGP D5 Dicom Theater Lite 13

This apparatus conforms to:

CE, IEC 60950, UL 60950, CAN/CSA C22.2 No. 60950 (c-UL), CCC.

National Scandinavian Deviations for Cl. 1.7.2 :

Finland: "Laite on liitettävä suojamaadoituskoskettimilla

varustettuun pistorasiaan"

Norway: "Apparatet må tilkoples jordet stikkontakt"

Sweden: "Apparaten skall anslutas till jordat uttag"

Explanation of symbols

14 MGP D5 Dicom Theater Lite

Explanation of symbols

Symbols on the display and power supply

On the display or power supply, you may find the following

symbols:

Symbols used throughout the manual:

Indicates the display is approved according to

the CE regulations

or

Indicates the display is approved according to

the UL regulations

or

Indicates the display is approved according to

the c-UL regulations

Indicates the display is approved according to

the DEMKO regulations

Indicates the display is approved according to

the CCC regulations

Indicates the USB connectors on the display

Warning or caution

Important notice or remark

Hint, tip

MGP D5 Dicom Theater Lite 15

Overview

(This page intentionally left blank.)

16 MGP D5 Dicom Theater Lite

(This page intentionally left blank.)

Introduction

MGP D5 Dicom Theater Lite 17

Introduction

About the system

MGP D5 Dicom Theater provides consistent image quality for

consulting, reviewing and training applications. The system offers

a turnkey solution, bundling high-bright medical grade projector,

flat panel display, dedicated display controller and MediCal

®

Pro

QA management software. MGP D5 Dicom Theater is available in

single- head and dual - head configurations.

MGP D5 Dicom Theater facilitates consulting and reviewing: this

ceiling-mount medical projection system combines ClearBase

and Projector Native White modes, has a user-friendly remote

control and features versatile connectivity to add a multitude of

both color and grayscale application sources, including PACS, X-

ray, ultrasound, endoscopy, etcetera.

The MGP D5 Dicom Theater system includes TheaterWatch

software, which enables you to calibrate the projector(s) based

on a visual algorithm.

About the separate components

The BarcoMed 2MP2CP display controller generates the images

for the display and the projector. It is a dual-head board with two

video outputs, which allows it to send video signals to two

different display devices. Both video outputs can be defined to

deliver the same video signal or two separate video signals.

Both heads have separate Lookup Tables (LUTs), so that the

display curve or Preset can be defined and stabilized separately

for both display devices.

The MGP D5 projector has multiple inputs, allowing it to be used

for projecting the medical images on a large screen or displaying

other images, like text, spreadsheets, presentations, etcetera.

The LCD display is used as review display in the MGP D5 Dicom

Theater system. Calibration and stabilization of the display is

Introduction

18 MGP D5 Dicom Theater Lite

done by means of the I-Guard® optical sensor, incorporated in

the bezel of the display.

The MediCal Pro software is used for defining the Preset the

display devices must be conform to and calibrate them to make

them conform to the Preset.

The TheaterWatch software is a systray tool normally operating in

background, which enables you to calibrate the projector(s)

based on a visual algorithm.

Other relevant documentation

• MediCal Pro® Installation and User Manual: Describes in

detail how to install and use the MediCal Pro software.

• TheaterWatch online help and user manual on CD-ROM:

Describes how to use TheaterWatch.

• User Guide for Medical Grade Projector MGP D5: Describes in

detail how to connect, use and control the MGP D5 projector.

• Installation Manual Ceiling Mount for MGP D5: Describes in

detail how to install the ceiling mount kit for the MGP D5

projector.

• Display User Manual

Important installation considerations

1. Make sure all equipment is switched off before installing.

2. In case you use a PCI extension box, please install the box

following the guidelines in its Installation or User's guide.

Quick installation overview

MGP D5 Dicom Theater Lite 19

Quick installation overview

MGP D5 Dicom Theater installation overview

To install the MGP D5 Dicom Theater system completely, you

have to follow these steps:

1. Install the BarcoMed display controller(s) in the PC. For more

information, please refer to the section about the “Display

controller installation”.

2. Install and connect the medical grade projector(s) and

display(s). For more information, please refer to the MGP D5

User Guide and the display User Manual.

3. Install the BarcoMed driver software. For more information,

please refer to the section about the “BarcoMed software

driver installation”.

4. Install the MediCal Pro and TheaterWatch software. For more

information, please refer to the sections about MediCal Pro

and TheaterWatch.

5. Start and use MediCal Pro and TheaterWatch. For more

information, please refer to the sections about MediCal Pro

and TheaterWatch.

Installation examples

This chapter illustrates the most common set-ups supported by

MGP D5 Dicom Theater.

Quick installation overview

20 MGP D5 Dicom Theater Lite

a) Single-head with 1 display and 1 projector

Figure 1

Proceed as follows:

1. Connect PC output video2 to the projector VGA input by

means of the DVI-to-VGA cable (15 m / 50 ft).

2. Connect PC output video1 to the display DVI video input by

means of the DVI-to-DVI cable.

BAR CO

Video1

DVI

Video1 (Head1)

Video2 (Head2)

VGA

Video2

Video1

Video2

Quick installation overview

MGP D5 Dicom Theater Lite 21

b) Single-head with two projectors

Figure 2

Proceed as follows:

1. Connect one PC video output to the first projector’s VGA input

by means of a DVI-to-VGA cable (15 m / 50 ft).

2. Connect the other video output to the second projector’s VGA

input by means of a DVI-to-VGA cable (15 m / 50 ft).

Video1

Video1 (Head1)

Video2 (Head2)

VGA

Video2

VGA

Video1

Video2

Page is loading ...

Barco DICOM Theater Lite, MGP 15 Dicom Theater, MGP D5 User manual

Related papers

Other documents