2. Aereco
  3. V2A

Aereco V2A Operating instructions

  • Hello! I've reviewed the provided instructions for the V2A moto-turbine replacement kit. This document provides a step-by-step guide for qualified technicians, detailing the removal of a old moto-turbine and installation of a new one with safety warnings and diagrams. I am ready to answer any questions you might have about this process.
  • Who should perform the replacement?
    What should be done before starting the replacement?
    What is the first step in the replacement process?
REPLACEMENT KIT FOR V2A MOTO-TURBINE
11.2014
V2A
1. Before any intervention,
cut o the fan supply
from the circuit breaker.
WARNING CONCERNING REPLACEMENT OF THE MOTO-TURBINE
ON A PRODUCT ALREADY INSTALLED :
·the replacement must be carried out by a qualified technician
·the manufacturer and the distributor decline any responsibility
in the event of a non conformity use of the product
·in the event of non respect of these recommendations, the
protection of the product can be compromised.
2. Withdraw the lid.
3. Unscrew and withdraw the
trap door of the electrical
case.
6. Unscrew the 3 suspension
screws from the moto-
turbine set.
4. Withdraw the supply
connector from the moto-
turbine.
7. Withdraw the moto-turbine
set by taking o the
suspensions first.
5. Release the seal in order to
enable the passage of the
electrical cable of the moto-
turbine.
8. Then take o the sleeve.
REPLACEMENT KIT FOR V2A MOTO-TURBINE
TF4198_D
Aereco S.A – 62 rue de Lamirault – Collégien – 77615 MARNE LA VALLEE CEDEX 3 – FRANCE – www.aereco.com
9. Open the packaging
containing the replacement
kit for V2A fan.
14. Connect the supply
connector of the moto-
turbine.
10. The replacement kit for V2A
fan is composed of a new
moto-turbine set.
15. Screw the suspensions
by separating the discs
towards outside in order to
avoid any friction :
11. Set up the new moto-
turbine set. Make sure that
the sleeve is fully encased.
16. Screw the trap door of the
electrical case.
12. Engage the suspensions in
their supports.
17. Place the lid.
13. Pass the moto-turbine
electrical cable under the
seal.
18. Close the lid.
19. Engage the circuit breaker
in order to supply the fan
and check its operation.
/