2. Aereco
  3. V4A Premium

Aereco V4A Premium Operating instructions

  • Hello! I have analyzed the provided document which describes the replacement procedure for the mototurbine in AERECO V4A series fans. The document includes step-by-step instructions with warnings, and covers both disassembly and reassembly. I am ready to assist you with any questions you have about this process.
  • What should be done before starting any intervention?
    Who should perform the replacement?
    What should be done after replacement to check operation?
REPLACEMENT KIT FOR V4A MOTOTURBINE
Note: Colours of wires may vary according to the kit version. Pictures not contractual.
REF. AVE359 and AVE490
1. Before any intervention,
cut o the fan supply from
the circuit breaker.
WARNING CONCERNING REPLACEMENT OF THE MOTO-TURBINE
ON A PRODUCT ALREADY INSTALLED :
·the replacement must be carried out by a qualified technician
·the manufacturer and the distributor decline any responsibility
in the event of a non conformity use of the product
·in the event of non respect of these recommendations, the
protection of the product can be compromised.
2. Withdraw the lid.
3. Unscrew (1 screw) and
withdraw the trap door of the
electrical case.
6. Unplug the mototurbine
supply wire.
4. Unscrew (4 screws) the
electrical case.
7. Unscrew the supply
(2screws).
5. Unscrew
REPLACEMENT KIT FOR V4A PREMIUM
Note: Colours of wires may vary according to the kit version. Pictures not contractual.
8. Unclip the electric card. 10. Remove the switch.
New supply set
9. Remove the connectors
(x2).
11. Place the switch of the
new supply set. Keep
the original position! (see
picture 10).
12. Put the new connectors.
2 AERECO – TF4540_C
Note: Colours of wires may vary according to the kit version. Pictures not contractual.
13. Clip the new electronic
card.
17. Cut the electric wire.14. Fix the supply (2 screws)
Warning: Tooth-pressure
must be in contact with the
supply!
15. Unscrew the mototurbine.
16. Withdraw the foam.
18. Unlock the exhaust spigot.
19. Withdraw the mototurbine.
20. Place the new moto-
turbine. Make sure that
the exhaust spigot is
well engaged! (no space
between mototurbine spigot
and exhaust spigot).
AERECO – TF4540_C 3
Note: Colours of wires may vary according to the kit version. Pictures not contractual.
21. Pull the supply wires. 26. Fix the supply mototurbine
wire on the electrical box.
22. Take the new fixing and tore
set...
23. ...and replace it by following
the same scheme.
Note: The wire must be
passed through the tore 2
turns!
24. Put the new foam.
25. Fix the mototurbine
(3screws).
27. Plug the mototurbine supply
wire.
28. Fix the electrical case on the
fan case (4 screws).
29. Fix the trap door (1 screw)
30. Put the lid back.
31. Engage the circuit breaker in
order to supply the fan and
check its operation.
REPLACEMENT KIT FOR V4A MOTOTURBINE
TF4540_C
Aereco S.A – 62 rue de Lamirault – Collégien – 77615 MARNE LA VALLEE CEDEX 3 – FRANCE – www.aereco.com
/