Ampac Heat Detector Addressable Installation guide

Ampac
Brand
Ampac
Model
Heat Detector Addressable
Type
Installation guide
ADVANCED WARNING
SYSTEMS
AHD05 Heat Detector NZ97
Installation Guide
Item Numbers: 4255-0341, 4255-0342
4255-0351, 4255-0352
MAN1539-1
N1236
Page 1
WORLD LEADER OF INNOVATIVE SOLUTIONS IN FIRE DETECTION AND ALARM SYSTEMS
Ampac Technologies Australia Tel: +61 8 9201 6100 Europe Tel: +44 (0) 1302 833 522 New Zealand Tel: +64 9 443 8072 www.ampac.net
Description:
The AHD05 Conventional Indicating NZ97 Heat
Detector is designed to operate with the NZ1, NZ400,
NZ3200 and FireFinder FACP’s using 3K3Ω EOL and
the NZ100 with 6K8Ω.
Detector is available in four versions, 57°C and 77°C,
sealed and unsealed.
Installation:
Observe anti-static precautions at all times
Surface Mount
Locate the detector over a conduit box or cable on a flat
surface, securing with two (2) screws tightened evenly
to prevent distortion.
Cable Entries
Two (2) knockout entries, one (1) either side of the
detector.
Terminate cables (see connection details above)
Fix the detector using the two (2) fixing screws
Insert screw caps to cover fixing screws
Install EOL resistor at the end of the detector circuit
Testing of Detector Operation
A heat gun can be used to operate the detector.
Note: The sealed version is not supplied with a terminal
block.
FACP
+
-
EOL
= END OF LINE
27.0
TEMPERATURE
INDICATOR (BLUE OR YELLOW )
CONNECTION DIAGRAM
AMPAC
MEASURING LINE VOLTAGE
LED
SEALED VERSION
HAS 2 X RED (+) AND
2 X BLACK (-) FLYING
LEADS
UNSEALED
VERSION
SCREW CAPS
MOUNTING
HOLES
* UNSEALED VERSION ONLY *
MOUNTING
HOLES
FACP
+
-
EOL
= END OF LINE
Figure 1: Sealed and un-sealed wiring diagram
  • Page 1 1

Ampac Heat Detector Addressable Installation guide

Ampac
Brand
Ampac
Model
Heat Detector Addressable
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents