Danfoss BasicGrip Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Danfoss BasicGrip Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1 2
3
4
5 6
7 8
9
10
Instructions
BasicGrip
Installation Guidelines
1
Attach the perimeter insu-
lation with tape on wall.
Note!
If additional insulation is 5 cm
thick or more attach the
perimeter insulation on the
additional insulation.
2
Cut off overlaps on both
ends of the first BasicGrip
panel.
3
Lay this BasicGrip panel
in the left hand corner of the
room.
4
Install the studded panels
one over the other. Cut wall
side overlapping edges off.
Cut the last panel to fit.
5
It is possible to press studs
home with feet.
6
When using liquid screed,
seal off the foil strips of the
perimeter insulation with PE-
string. On cement screed, the
foil is loosely placed on the
studded panel.
7
The pipes can be laid by
one person by using the pipe
dispensing wheel.
8
Lay pipes in snail form, at
first with double spacing in
order to maintain the calcu-
lated pipe distances.
9
Lay pipes in snail form
throughout the room.
10
Install expansion joint pro-
file e.g. for door thresholds, as
shown, using the Basic move-
ment gap strip.
Danfoss HES VI.CT.F1.02 © Danfoss 11/2008 1
/