Panasonic WVCK1420 - COLOR MONITOR Operating instructions

Colour Monitor

WV-CK1420

Before attempting to connect or operate this product, please read these instructions carefully.

ENGLISH

DEUTSCH

FRANÇAIS

ESPAÑOL

ENGLISH VERSION

THIS APPARATUS MUST BE EARTHED.

To ensure safe operation the three-pin plug supplied must be inserted

only into a standard three-pin power point which is effectively earthed

through the normal household wiring. Extension cords used with the

equipment must be three-core and be correctly wired to provide con-

nection to earth. Wrongly wired extension cords are a major cause of

fatalities.

The fact that the equipment operates satisfactorily does not imply

that the power point is earthed and that the installation is completely

safe. For your safety, if in any doubt about the effective earthing of

the power point, consult a qualified electrician.

The lightning flash with arrowhead sym-

bol, within an equilateral triangle, is

interned to alert the user to the presence

of uninsulated "dangerous voltage" within

the product's enclosure that may be of

sufficient magnitude to constitute a risk of

electric shock to persons.

The exclamation point within an equilat-

eral triangle is intended to alert the user

to the presence of important operating

and maintenance (servicing) instructions

in the literature accompanying the appli-

ance.

WARNING:

TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOIS

TURE.

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK), NO USER

SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE

PERSONNEL.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

For Australia

FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CARE-

FULLY.

This appliance is supplied with a moulded three pin mains plug for your

safety and convenience.

A 13 amp fuse is fitted in this plug.

Should the fuse need to be replaced please ensure that the replacement

fuse has a rating of 13 amp and that it is approved by ASTA or BSI to

BS1362.

Check for the ASTA mark

H or the BSI mark G on the body of the

fuse.

If the plug contains a removable fuse cover you must ensure that it is

refitted when the fuse is replaced.

If you lose the fuse cover the plug must not be used until a replacement

cover is obtained.

A replacement fuse cover can be purchased from your local Panasonic

Dealer.

IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCK-

ET OUTLET IN YOUR HOME THEN THE FUSE SHOULD BE

REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY.

THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE

CUT OFF PLUG IS INSERTED INTO ANY 13 AMP SOCKET.

If a new plug is to be fitted please observe the wiring code as shown

below.

If in any doubt please consult a qualified electrician.

WARNING: This apparatus must be earthed.

IMPORTANT

The wires in this mains lead are coloured in accordance with the follow-

ing code.

Green-and-yellow: Earth

Blue: Neutral

Brown: Live

As the colours of the wire in the mains lead of this appliance may not

correspond with the coloured markings identifying the terminals in your

plug, proceed as follows.

The wire which is coloured green-and-yellow must be connected to

the terminal in the plug which is marked with the letter E or by the earth

symbol

I or coloured green or green-and-yellow.

The wire which is coloured blue must be connected to the terminal in

the plug which is marked with the let-

ter N or coloured black.

The wire which is coloured brown

must be connected to the terminal in

the plug which is marked with the let-

ter L or coloured red.

How to replace the fuse

Open the fuse compartment with

a screwdriver and replace the fuse

and fuse cover.

For U.K.

The serial number of this product may be found on the

rear of the unit.

You should note the serial number of this unit in the

space provided and retain this book as a permanent

record of your purchase to aid identification in the event

of theft.

Model No.

Serial No.

Wij verklaren als enige aansprakelijke, dat het product waarop deze

verklaring betrekking heeft, voldoet aan de volgende normen of

andere normatieve documenten, overeenkomstig de bepalingen

van Richtlijnen 73/23/EEC en 89/336/EEC.

Vi erklærer os eneansvarlige for, at dette produkt, som denne dekla-

ration omhandler, er i overensstemmelse med standarder eller

andre normative dokumenter i følge bestemmelserne i direktivene

73/23/EEC og 89/336/EEC.

Vi deklarerar härmed värt fulla ansvar för att den produkt till vilken

denna deklaration hänvisar är i överensstämmelse med standard-

dokument, eller andra normativa dokument som framställs i EEC-

direktiv nr. 73/23 och 89/336.

Ilmoitamme yksinomaisella vastuullamme, että tuote, jota tämä

ilmoitus koskee, noudattaa seuraavia standardeja tai muita ohjeel-

lisia asiakirjoja, jotka noudattavat direktiivien 73/23/EEC ja

89/336/EE. säädöksiä.

Vi erklærer oss alene ansvarlige for at produktet som denne

erklæringen gjelder for, er i overensstemmelse med følgende

normer eller andre normgivende dokumenter som følger bestem-

melsene i direktivene 73/23/EEC og 89/336/EEC.

We declare under our sole responsibility that the product to which

this declaration relates is in conformity with the standards or other

normative documents following the provisions of Directives

EEC/73/23 and EEC/89/336.

Noi dichiariamo sotto nostra esclusiva responsabilità che il prodotto

a cui si riferisce la presente dichiarazione risulta conforme ai

seguenti standard o altri documenti normativi conformi alle dispo-

sizioni delle direttive CEE/73/23 e CEE/89/336.

- 1 -

CONTENTS

PREFACE ............................................................................................................................................................................................ 1

FEATURES .......................................................................................................................................................................................... 1

PRECAUTIONS ................................................................................................................................................................................... 1

MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS ........................................................................................................... 2

ADVANCED CONTROL OPERATION ................................................................................................................................................. 3

CABLE INFORMATIONS ..................................................................................................................................................................... 4

CONNECTION ..................................................................................................................................................................................... 4

SPECIFICATIONS ............................................................................................................................................................................... 4

PREFACE

The Panasonic’s Colour Monitor WV-CK1420 produces

sharp colour pictures and audio output.

FEATURES

• Approx. 335.4mm (13 inches) diagonal actual visual

size.

• Looping through BNC connectors for video input and out-

put.

• Looping through RCAconnectors for audio input and out-

put.

• Maximum 0.7W for speaker output.

PRECAUTIONS

• Do not block the ventilation slots.

• Do place the video monitor at least 5cm (2 inches) apart

from the wall.

• Do not expose the monitor to water or moisture.

• Do not operate the monitor if it becomes wet.

• Do take immediate action if ever the monitor does

become wet. Turn power off and refer servicing to quali-

fied service personnel. Moisture can damage the monitor

and also create the danger of electric shock.

• Do not drop metallic parts through slots. This action

could permanently damage the monitor. Do turn power

off immediately and refer servicing to qualified service

personnel.

• Do not attempt to disassemble the monitor. To prevent

electric shock, do not remove screws or cover. There are

no user serviceable parts inside. Refer servicing to qual-

ified service personnel.

• Do not use the monitor beyond its temperature, humidity

or power source ratings.

a) Ambient temperature must not range beyond –10°C

- +50°C (14°F–122°F).

b) Avoid using the monitor when humidity is above

90%.

c) The input power must be 220 - 240V AC

• Do not stack two or more sets.

If more than two monitors are used, place them less than

15cm apart. Otherwise, the monitors may produce noise

on the display screen.

ENGLISH

- 2 -

MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS

1. Power Switch (POWER, ON/OFF)

This is a push-push type switch which turns the power of

this monitor on and off.

Press once and the switch remains down (;) for turning

on the power of monitor.

Press again, the switch comes up (l ) for turning off the

power of the monitor.

2. Audio Control Buttons (–AUDIO+)

Press these buttons to increase or decrease the sound

volume level.

3. Menu Button (MENU)

Press to display the setup display or move the cursor

down one line in the setup display.

4. Level Control Button (–LEVEL+)

Press these buttons to adjust level of the selected item in

the setup display, or select a parameter in the setup dis-

play.

5. Power Indicator

Is on (red) when the Monitor’s power is turned on.

6. Audio Output Connector (AUDIO OUT)

The audio input signal connected to the audio input con-

nector u is looped through to this connector.

7. Audio Input Connector (AUDIO IN)

For input of audio signal from an outboard device.

8. Video Output Connector (VIDEO OUT)

The video input signal connected to the video input con-

nector o is looped through to this connector and termi-

nated automatically.

9. Video Input Connector (VIDEO IN)

For input of the PAL composite video signal from an out-

board device.

POWER

ON

OFF

–AUDIO+ MENU –LEVEL+

Color Monitor WV-CK

1420

AUDIO VIDEO

OUT IN OUT IN

COLOUR

- 3 -

ADVANCED CONTROL OPERATION

• Displaying the Setup Display

1. Turn on the Power Switch of the Monitor.

2. Press the MENU button, the setup display shown below appears on the monitor screen.

It will disappear automatically when no operation takes place for about 3 seconds.

• Adjustment

3. Move the cursor to LANGUAGE by pressing the MENU button.

4. Select the desired LANGUAGE parameter by pressing the LEVEL (–) or (+) buttons, Pressing the buttons will toggle the setup

display in selected language as shown below.

5. Move the cursor to BRIGHT, CONTRAST, PICTURE or COLOUR by pressing the MENU button, then adjust the level of the

selected item by pressing the LEVEL (–) or (+) buttons.

While adjusting the selected item level, the display changes to the indicator as shown below.

6. To reset the monitor to the default settings, move the cursor to NORMAL SETTINGS by pressing the MENU button. Then press

the LEVEL (+) button to return to the factory default settings.

7. To exit the setup display, press the MENU button repeatedly until the cursor is passed over LANGUAGE or wait for about 3 sec-

onds until it disappears.

LANGUAGE ENGLISH

BRIGHT

CONTRAST

PICTURE

COLOUR

NORMAL SETTINGS

ENGLISH FRANÇAIS

LEVEL+

LEVEL–

DEUTSCH

Item Effect Indicator

BRIGHT

CONTRAST

PICTURE

Darker Brighter

Less More

Soft

Sharp

Less More

32

BRIGHT

32

CONTRAST

32

PICTURE

32

COLOUR

BRIGHT

CONTRAST

PICTURE

COLOUR

LEVEL+

LANGUAGE ENGLISH

NORMAL SETTINGS

BRIGHT

CONTRAST

PICTURE

COLOUR

LANGUAGE ENGLISH

NORMAL SETTINGS

- 4 -

SPECIFICATIONS

Power Source: 220 - 240V AC, 50Hz

Power Consumption: Approx. 66W

Screen Size: 371.8mm diagonal tube screen size, 90° deflection

335.4mm diagonal actual visual size

Horizontal Resolution: 330TV lines at centre

Video Input: 1.0V[p-p] composite/75Ω, BNC with Auto Termination

Audio Input: –8dB/Hi-z, RCA standard jack

Speaker Output: 0.7W

Sweep Linearity: Horizontal: Less than 5%

Vertical: Less than 5%

Sweep Geometry: Less than 2%

Ambient Operating Humidity: Less than 90%

Ambient Operating Temperature: –10°C - +50°C (14°F - 122°F)

Dimensions: 366(W) x 346(H) x 365(D)mm (14-7/16”(W) x 13-10/16”(H) x 14-6/16”(D))

Weight: 9.6kg (21.2lbs.)

Weights and dimensions shown are approximate.

Specifications are subject to change without notice.

CABLE INFORMATIONS

Power Cable

1. Keep the Power Switch q in the OFF position during

installation.

2. Connect the Power Cord to a grounded electrical outlet.

Video Cable

1. Use the RG-59/U (3C-2V), RG-6/U (5C-2V), RG-11/U

(7C-2V) or RG-15/U (10C-2V) coaxial cable.

2. Up to 10 monitors can be hooked up in this configuration

before signal loss occurs. Total cable length should not

exceed 150m (500 feet).

3. Wiring Precautions:

• Do not bend coaxial cable into a curve whose radius

is smaller than 10 times of its diameter:

• Never crush or pinch the cable.

All these will change the impedance of the cable and

cause poor picture quality.

Recommended maximum cable length

Cable RG-59/U RG-6/U RG-11/U RG-15/U

(3C-2V) (5C-2V) (7C-2V) (10C-2V)

Recommended 250m 500m 600m 800m

maximum

cable length (825ft) (1650ft) (1980ft) (2650ft)

CONNECTION

AUDIO IN AUDIO OUT AUDIO IN AUDIO OUT

VIDEO IN

VIDEO INVIDEO OUT

BNC Connector

VIDEO OUTVIDEO IN VIDEO OUT

Camera

AUDIO VIDEO

OUT IN OUT IN

AUDIO VIDEO

OUT IN OUT IN

AUDIO VIDEO

OUT IN OUT IN

Page is loading ...

Matsushita Electric Industrial Co., Ltd.

Central P.O. Box 288, Osaka 530-91, Japan

N0499-0 TQB4C1A188 Printed in Taiwan

Gedruckt in Taiwan

Imprimé à Taiwan

Impreso en Taiwan

Panasonic WVCK1420 - COLOR MONITOR Operating instructions

This manual is also suitable for

Panasonic WVCK1420 - COLOR MONITOR Operating instructions

in other languages

Related papers

Other documents