This product is not a substitute for adult supervision.
Questions - Please call 1-800-845-9236 or vist www.kidkusion.com
KidKusion is a registered trademark of KidKusion Inc.
C 2011 KidKusion Inc. All Rights Reserved
Made in the USA
Distributed by KidKusion Inc.
R
“Because Kids Will Be Kids!”
www.kidkusion.com
1-800-845-9236
Retractable DRIVEWAY GUARD
INSTALLATION AND USE INSTRUCTIONS
IMPORTANT NOTICE: Driveway Guard is NOT intended to be used as a swimming pool barrier or a gate.
1. Determine placement of Driveway Guard across your driveway.
2. Install the two ground sleeves (12” PVC tubes on either side of driveway).
3. Using hammer and block of wood, pound first ground sleeve into the ground a few inches from edge of
driveway. Due to difference in soil types, it may be necessary to dig out hole with hand shovel first and refill dirt
around ground sleeve. Do the same with the second ground sleeve on the opposite side of driveway.
Do not install Driveway Guard unit directly in ground without ground sleeves.
The ground sleeves should be installed straight up and down and flush with ground level to allow proper
retraction of driveway guard. In some cases where the ground is soft, it may require that the ground
sleeves lean slightly outward away from the driveway. (Fig. 2) This will allow the poles to stand up
straight and the net not to sag when it is extended.
4. Insert pole on bottom of Driveway Guard unit into first ground sleeve.
5. Slowly, pull out second pole and net. Extend across driveway and insert pole into second ground sleeve.
6. To retract, lift end of net with pole out of ground sleeve, slide net down pole close to the bottom of pole, hold
onto pole and walk the net slowly back to the unit. Do not release net until it is fully retracted. This will ensure that
net is evenly aligned and less likely to fold over while being retracted into unit. Net must be held straight as unit
retracts (see Fig. 1). If net becomes folded when retracting, pull net out slowly until it is straight again and retract
slowly. (Net has been designed to retract slowly as a safety feature).
7. Store retracted unit with pole for next use. Leave ground sleeves in place in ground (No need to remove and
re-insert!). Cover ground sleeves with black vinyl caps provided to keep out dirt and water. Ensure that ground
sleeves are flush with ground level so they will not interfere with mowing grass.
Please remember:
This product has been designed only as a visual barrier.
It is not intended to be a physical barrier to hold children.
Adult supervision is always required when young children play near road!
• Slide net down towards bottom of pole before retracting.
• Net must be held straight as unit retracts.
• DO NOT REMOVE Plastic cap on top of driveway guard unit.
• Removal of cap voids the warranty.
Fig. 1
Free Pole leans
slightly outward
Lean
Ground
Sleeve
outward
slightly and
hammer in
ground
Soft Ground Installation
Fig. 2
Lean Ground
Sleeve outward
slightly and
hammer in ground
Ground
Retractor Unit
leans slightly
outward
US Patent No. 6,807,999
Model 4700,4725
4730 & 4735
This product is not a toy. Do no allow
children to play with it.
-
1
KidKusion 4725 Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Play It Safe RPDN26 Installation guide
-
Coleman Power Steel Owner's manual
-
Crown C6C Owner's manual
-
Detail K2 AVAL8219 Installation guide
-
Bestway 56082 Owner's manual
-
Patriot Products 10F-CSV User manual
-
Patriot 5F, 6F, 8F, 10F User manual
-
Rukket Sports FENCE100 Operating instructions
-
Marantec Comfort 250 Owner's manual
-
DAHON Folder 1987 User manual
