DELUXE COLLECTION
1. Turn off power on water cooler.
2. Remove Water Filter Bottle away from water cooler and place
over a sink or basin.
3. Sanitise the water cooler or dispenser, with warm water and
detergent, and then rinse out thoroughly.
Note: Sanitising Sachet packs are available from
Aquaport on 1300 764 325.
4. Wash all Water Filter Bottle parts (except filter cartridge)
with warm water and detergent and then rinse out thoroughly.
5. Remove filter cartridge from plastic and immerse in ambient
water for 20 minutes. Shake filter vigorously under water to
dislodge loose carbon particles.
6. Reassemble Water Filter Bottle as per your Water Filter
Bottle (model AQP-FBOT4) installation manual and screw the
new filter cartridge in a clock wise direction into the Filtered
Water Chamber of the Water Filter Bottle.
Note: Do not over tighten.
Note: For complete installation instructions refer to your Water
Filter Bottle installation manual.
* Use with municipal water only. Do not use with water that is
microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
www.aquaport.com.au