Hukoro NF50959-02h Operating instructions

Brand
Hukoro
Model
NF50959-02h
Type
Operating instructions

This manual is also suitable for

Bulbs
(not included)
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
EXPLODED PARTS INSTALLATION
HARDWARE INCLUDED
Fixture
Mounting Unit Mounting Screws
Wire Nuts
FixtureIron Rack
Iron Rack
Ball Nuts (B)
Stem E
Stem D
Stem E
Ball Nuts
(A&B)
Ball Nuts (A)
Mounting UnitCover
Cover
Decorative
Nut
Decorative Nut
Stems(A~D) Canopy
Canopy
Mounting
ScrewsWire Nuts
Stem C
Stem B
Stem A
Junction Box
(not included) STEP 1
Unscrew the ball nuts (A) from the mounting unit.
Use the mounting screws to attach the
mounting unit to the junction box (not included).
Wire
strippers
Ladder Safety
glasses
Electrical
tape
Phillips
screwdriver
Flat blade
screwdriver Pliers
CAUTION
Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect
in the wire, do not attempt installation.
Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning off the circuit breaker or by
removing the fuse at the fuse box.
If you need further assistance, please contact us by Email: [email protected]
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
@
Screw the stem E into the fixture.
STEP 2
Adjust arms to proper position.
STEP 3
Make the electrical connection from the junction box (not included) to the
fixture. Connect the ground wire to the mounting unit using the preinstalled
green ground screw. Next, connect the positive, negative and ground wires
with the supplied wire nuts. Secure with electrical tape.
ASSEMBLY INSTRUCTIONS INSTALLATION
STEP 9
STEP 7
Install stem connecting the upper and
lower ends of the lamp body.
Install stems based on the desired length of the
item on the fixture, adding conopy one finished.
STEP 6
Attach the iron rack onto the fixture
using ball nuts (B) as shown.
STEP 4
Place the cover onto the iron rack,
then secure with decorative nut.
STEP 5
Install bulbs (not included)
Secure the canopy to the
mounting unit with the
ball nuts (A).
*junction box
(not included)
STEP 8
White wire from
the fixture
Ground wire from
the Fixture
Black wire from
the fixture
Black or Red wire (hot)
from the junction box
White wire (neutral)
from the junction box
Bare or Green ground wire
from the junction box
*Green Ground Screw
*Sealing tape
(not included)
  • Page 1 1
  • Page 2 2

Hukoro NF50959-02h Operating instructions

Brand
Hukoro
Model
NF50959-02h
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents