Design House 519660 Operating instructions

Design House
Brand
Design House
Model
519660
Category
Racks
Type
Operating instructions

This manual is also suitable for

AJAX PENDANT
ASSEMBLY/INSTALLATION INSTRUCTIONS
WARNING: Risk of Fire. Min 75ºC supply conductors. Consult a qualied electrician to ensure correct
installtion.
Turn off the main power at the circuit breaker before installing the xture, in order to prevent possible
shock.
#519660
Customer Service 1-800-558-8700
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)
standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a
qualied electrician.
Remove the xture and the mounting package from the box and make sure that no parts are missing by
referencing the illustrations on the installation instructions.
Phillips screwdriver.
CAUTION
GENERAL
TOOLS REQUIRED
ASSEMBLY AND INSTALLATION
ASSEMBLY AND INSTALLATION
(CONT.)
Please read carefully and save these instructions, as you may need them at a later date.
Turn off the power at fuse or circuit breaker.
Turn on the power at fuse or circuit breaker.
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
JUNCTION BOX
MOUNTING SCREWS
WIRE NUTS
CROSS BAR
GROUND SCREW
FIXTURE
BALL NUTS
STEM
SHORT STEMS
BOTTOM STEM
LAMP HOLDER
FIXTURE SCREWS
#519678
1. Gently take all parts out of the package, lay them on a smooth surface, unscrew the BALL NUTS
and the FIXTURE SCREWS. Attach the CROSS BAR to the JUNCTION BOX using (2) MOUNTING
SCREWS.
2. Attach BOTTOM STEM to LAMP HOLDER. Then, install STEM and SHORT STEMS based on
the desired length of the item, adding FIXTURE once nished.
3. Make wire connections with WIRE NUTS:
A - Connect the black wire from Fixture to the black supply wire.
B - Connect the white wire from Fixture to the white supply wire.
C - Attach the xture ground wire to the CROSS BAR with the green GROUND SCREW. Then
connect it to the supply ground wire with a WIRE NUT. Carefully tuck wires back into the JUNCTION
BOX.
4. Attach the FIXTURE to the CROSS BAR through SCREW HOLES as shown, and secure it with
BALL NUTS.
5. Attach the IRON RACK to the LAMP HOLDER and secure it with SOCKET RING.
6. Install BULB (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
7. Attach the IRON RACK (01) to the IRON RACK as shown, and secure it with DECORATIVE NUTS.
IRON RACK
IRON RACK (01)
DECORATIVE NUTS
SOCKET RING
BULB (not included)
A
B
C
SCREW HOLES
Item # 519660 (AJAX PENDANT GAL)
Item # 519678 (AJAX PENDANT BRZ)
  • Page 1 1

Design House 519660 Operating instructions

Design House
Brand
Design House
Model
519660
Category
Racks
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents