2. Pella
  3. Rolscreen

Pella Rolscreen Service Instruction

  • Hello! I am an AI chatbot trained to assist you with the Pella Rolscreen Service Instruction. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What tools are required to adjust the roller tension on a Pella Rolscreen?
    How do I remove the Rolscreen?
    How do I adjust the roller tension?
    How do I reinstall the Rolscreen?
    What should I do if the roller tension is too loose or too tight?
    What precautions should I take when operating the retractable screen?
Rev. 10/14/2016
© 2016 Pella Corporation
Page 1 of 3
Part Number: 81XA0000
These instructions apply to:
Model 2 Rolscreen Retractable Screen 1997-2/2017
1
Rolscreen Removal and Roller Tension Adjustment:
The tension system which controls the rewinding of the screen cloth is similar to a pull-down shade.
NOTE: If tension does not increase by winding spring per the following instructions, the spring may be broken.
Replace roller assembly.
A. Remove cover if it is in place.
B. Position the screen by raising or lowering the screen so the
pull bar is 12" to 20" from the top. Remove each end of the
pull bar from the screen guides as shown.
1B
1C
1D
C. Remove the screen from the screen assembly.
D. On the tab end of the roller assembly, position the
chamfer down.
Tools Required:
• Locking Pliers
Rolscreen® Retractable Screen Adjusting Roller Tension
Service Instruction
Page 2 of 3
A. Install the tab of the roller assembly (chamfer up) into the nylon
end cap.
2
Rolscreen Installation:
E. Using locking pliers, rotate the tab in a counter-clockwise
direction until the catch engages.
F. Use the pliers to turn the tab clockwise 15 times to wind the
spring. Before removing the pliers from the tab, turn the pliers
counter-clockwise until the catch re-engages.
1
Rolscreen Removal and Roller Tension Adjustment (Continued):
1E
2A
2B
2C
B. Slide the other end of the roller assembly into the other nylon
end cap.
C. Pull screen down 12" to 20" and rotate the pull bar between the
screen guides. Insert one end in each guide.
Page 3 of 3
Operating a retractable screen may result in a static discharge. A static discharge in the
presence of a flammable substance such as aerosol lubricant could cause ignition. To
avoid injury and/or property damage, do not use any flammable substance on a retractable screen.
2
Rolscreen Installation (Continued):
D. Push screen cloth behind screen guides. (The screen will feed
into the guides when operating the screen.)
E. Test screen operation. If the roller tension seems too loose
or too tight; repeat removal and adjustment steps to add or
remove tension by turning the tab to increase or decrease
tension as shown in steps 1E-1F
2D
!
CAUTION
F. Reinstall cover.
/