Saab 400 112 140 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Saab 400 112 140 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Saab 9-3 -M03
9-3
MONTERINGSANVISNING
·
INSTALLATION INSTRUCTIONS
MONTAGEANLEITUNG
·
INSTRUCTIONS DE MONTAGE
Saab 9-3 -M03
CD changer
Accessories Part No. Group Date Instruction Part No. Replaces
400 112 140 9:36-7 Jun 04 50 36 363 50 36 363 Apr 98
D936A601
2 50 36 363
Saab 9-3 -M03
1 CD changer (sold separately)
2 Bracket, rear, CD changer
3 Bracket, front, CD changer
4 Bracket, rear
5 Bracket, front
6 Screw (x4)
7 Nut (x6)
8CD-magazine
9 Tape (x4)
1
3
4
5
7
6
7
7
8
D936A602
2
6
9
50 36 363 3
Saab 9-3 -M03
1 Fold the left-hand rear side trim out of the way in
the luggage compartment.
2 Fit the CD changer front and rear brackets to the
welded screws on the left-hand inner wheel
arch.
3 Unscrew the 4 transport screws (2 marked red
on each short side) and remove the same. Put
them in the small plastic bag and cover the
holes with the supplied pieces of tape. Check
that the mounting position screws are in the
vertical position (V).
Screw on the CD changer bracket.
2
2
D936A603
3
3
V
H
V
H
3
4 50 36 363
Saab 9-3 -M03
4 Front cut:
Lay the side trim against the bracket and cut
along the length of the bracket with a knife
(120 mm).
Rear cut:
Make a cut just behind the screws.
5 Make a cut behind the front mounting towards
the floor for the cable and extract the cable from
behind the trim. Refit the side trim.
6 Connect the CD changer.
7 Insert the projecting rear part of the CD bracket
into the rear bracket, see illustration. Screw on
the front of the CD bracket.
8 Insert the CD magazine.
9 Connect the diagnostics tool, select Audio
System and the “Programming”menu. “Marry”
the CD changer to the car. This is a condition for
proper operation of the CD changer.
For operation of the CD changer, see the
Owner’s Manual.
Important
If the CD changer is to be removed from the car
and refitted in the same car, the diagnostics tool
must be connected and the CD changer
"divorced" from the car via Audio System and the
“Programming”menu.
The CD changer must be divorced while connected
to the car it was married to.
4
4
7
7
5
D936A604
WARNING
The CD changer is a class 1 laser product
· Service and repair of the CD changer must
only be carried out by a qualified technician.
· If the outer casing of the CD changer is
damaged, laser radiation may occur which
may cause personal injury.
/