Saab 400 112 124 Installation guide

Brand: Saab

Model: 400 112 124

Type: Installation guide

Saab 400 112 124 is a CD changer designed for use with Saab 9-5 5D vehicles. It is a Class 1 laser product and should be serviced by qualified technicians only. The CD changer can hold up to 6 CDs and can be mounted in the side trim's storage compartment. It must be "married" to the car using a diagnostics tool in order to function properly. Once married, the CD changer can be controlled through the car's audio system. If the CD changer is to be removed and refitted in the same car, it must first be "divorced" from the car using the diagnostics tool.

Saab 9-5 5D

9-5 Installation instructions

SCdefault

MONTERINGSANVISNING

INSTALLATION INSTRUCTIONS

MONTAGEANLEITUNG

INSTRUCTIONS DE MONTAGE

SITdefault

Saab 9-5 5D

CD changer

Accessories Part No. Group Date Instruction Part No. Replaces

400 112 124 9:36-15 Jun 04 50 39 490 50 39 490 Jul 98

E930A056

1 CD changer (sold separately)

2 Washer (4x)

3 Screw (4x)

4 CD magazine

2 50 39 490

Saab 9-5 5D

1 Tip the rear seat’s left-hand backrest forward

and remove the cover between the backrest and

left-hand rear door.

2 Lift out the concealing panel.

3 Remove the left-hand storage compartment in

the floor.

4 Detach the rear roof covering and unplug the

connectors for the lighting.

5 Remove the left-hand D-pillar trim and the left-

hand concealing panel support (3 screws).

6 Remove the four screws at the top of the left-

hand side trim and lift out the trim.

E930A057

50 39 490 3

Saab 9-5 5D

7 Make a hole for the wiring in the side trim’s stor-

age compartment as marked on the rear of the

trim. Also drill holes with a 4 mm drill bit for the

CD changer’s mounting screws as marked on

the rear.

8 Undo and remove the 4 transport screws

(2 coloured red on each short side) and place

them in a small plastic bag which can be handed

to the customer. Check that both mounting posi-

tion screws (1 on each side) are in the vertical

position (V).

9 Mount the CD changer in the side trim’s storage

compartment using the screws and washers

supplied. Connect the CD changer.

10 Fit the CD magazine.

11 Connect the diagnostics tool, select Audio Sys-

tem and the “Programming”menu. “Marry” the

CD changer to the car. This is a condition for

proper operation of the CD changer.

For operation of the CD changer, see the Own-

er’s Manual.

Important

If the CD changer is to be removed from the car

and refitted in the same car, the diagnostics tool

must be connected and the CD changer

"divorced" from the car via Audio System and the

“Programming”menu.

The CD changer must be divorced while connect-

ed to the car it was married to.

E930A058

4 50 39 490

Saab 9-5 5D

12 Refit the side trim and tighten the four screws at

the top of the trim.

13 Refit the concealing panel support (3 screws)

and D-pillar trim.

14 Press the roof covering back into place.

15 Fit the storage compartment in the floor.

16 Lift the concealing panel in place.

17 Fit the cover panel between the rear left door

and the backrest and fold back the rear seat

backrest.

WARNING

The CD changer is a Class 1 laser product.

· CD changer service and repairs should be car-

ried out by qualified technicians only.

· If the casing of the CD changer is damaged,

laser radiation may be emitted and entail a risk

of injury.

E930A059

12 12

Saab 400 112 124 Installation guide

Saab 400 112 124 Installation guide

Saab 400 112 124 Installation guide

Related papers

Other documents