Dometic VT2500 User manual

Brand: Dometic

Model: VT2500

Type: User manual

Display panel

First check whether:

 the cassette has been inserted correctly

 the vehicle water tank has been filled

 the power supply has been switched on (main switch).

Once the power supply for the vehicle has been switched on, the toilet is also auto-

matically switched on and a vacuum is produced in the system for the first time.

The yellow LED illuminates on the display panel.

After approx. 1 minute this procedure is finished. The green LED illuminates.

By lifting the pedal allow a little water to enter the toilet, so that the closure

on the base of the receptacle is covered.

Repeat this procedure after each flushing.

If the cassette is full or it is removed, the red LED illuminates and the pump is

switched off.

It cannot be used further until the cassette has been emptied or it is

inserted again.

Flushing the toilet

To flush, press the pedal down on the left side of the toilet. During the flushing

process close the seat lid; this will considerably reduce the noise.

The toilet may only be flushed whilst the green LED is illuminated.

In order to be able to use the toilet as often as possible for one cassette filling,

please economize on the water and paper. Normally approx. 0.4 L water are suffi-

cient for flushing once.

SSHHOORRTT IINNSSTTRRUUCCTTIIOONNSS

VACUUM-TOILET

for Caravan and Motorhomes

VT 2500

GELB (pump is running )

TOILET CANNOT BE USED

GREEN (ready)

RED (Cassette full or casset-

te removed)

TOILET CANNOT BE USED

LED

The system is ready for operation!

242 6001 - 82

Only use commercially available toilet paper with 2 layers.

Since the system always operates under a vacuum and is closed

hermetically, no smell can develop.

Never press the pedal whilst sitting on the toilet or if

the seat lid is open!

For the environment's sake, do not use

any chemicals.

Do not dispose any solid or non-dissolving objects

such as plastic cans or paper towels in the toilet. These

items can cause damage or plugging of the system !

Removing the cassette

To remove the cassette, raise the locking latch (A) underneath the grip.

When inserting the cassette

again, make sure that it is inser-

ted exactly in the opening provi-

ded and that after pushing it in,

the locking latch has engaged

again.

Cleaning

Since the toilet receptacle is made of ceramic materi-

al, you can clean it in the same way as a household

toilet. For cleaning the plastic parts (such as the lid,

seat, outer covering) please only use water with a

mild cleaning agent. If possible, rinse the cassette

with fresh water each time it has been emptied.

To avoid deposits clean also the flush ball (Fig.1) and

the sealing ring (Fig. 2 with the flush ball opened)

Occasional clean the area where the excrements are transferred at the connection

(Fig. 3) and on the base station

(Fig. 4-5).

For

emptying

open here

Dometic AB

Torggatan 8

S-17154 Solna

Tel.: +46 -8 501 025 00

Fax.: +46 -8 501 025 98

Dometic GmbH

In der Steinwiese 16

D - 57074 Siegen

Tel.: +49 -(0)271 692 0

Fax.: +49 -(0)271 692 300

Dometic VT2500 User manual

Dometic VT2500 User manual

Dometic VT2500 User manual

Related papers

Other documents