Rev-A-Shelf 4FSCO-18SC-1 Operating instructions

Rev-A-Shelf
Brand
Rev-A-Shelf
Model
4FSCO-18SC-1
Type
Operating instructions

This manual is also suitable for

INSTALLATION INSTRUCTIONS: 4FSCO FOOD STORAGE CONTAINER ORGANIZER
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
FOOD STORAGE CONTAINER ORGANIZER
TOOLS REQUIRED:
15 MIN
ESTIMATED ASSEMBLY TIME:
CARE AND MAINTENANCE:
Clean with a damp cloth and
wipe parts dry.
I-4FSCO-0217
#2
STEP 1
To assemble the slides, attach
the cross bar into the feet as
shown in Fig 1.1.
Attach the left and right slides
respectively to the top of
the feet. You will hear/feel
a “Snap” when connected
completely (See Fig 1.2)
Once slides are assembled, set
them to the side.
3
32
For video instruction visit:
rev-a-shelf.com/videos
FIGURE 1.1 FIGURE 1.2
Remove the slide triggers from
their wrapping.
Turn your FSCO wood box
over and locate the pre-drilled
holes on the front lip of the
box, refer to Figure 2.1 for
help locating the holes.
Using the provided screws,
attach the left and right sided
triggers and set FSCO box to
the side as shown in Figure 2.2.
NOTE
Release triggers are side
sensitive and are marked with
an “L” & “R” for Left and Right.
STEP 2
Place template (See Fig 3)
into cabinet and position front
edge to where the back of
your door will be.
Inset door = set back the thickness of
your door
Overlay = place at the front edge of
cabinet
Using an awl or pencil, mark
through the bold dotted screw
locations onto your cabinet
oor. Remove template when
done. Using your 3/32” drill
bit, pre-drill your cabinet oor
in all 8 locations being sure to
NOT drill through the cabinet
oor completely.
Lay your assembled slide set
over the top of the marked
holes. Using the 8 screws
provided, attach the slides to
the cabinet oor through the
grey slide feet holes.
Place your FSCO wood box
with attached triggers on top
of the slides and push back
until you hear the “Click”
sound. You are now ready to
organize your FSCO drawer.
STEP 3
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
Pre-drilled holes
Slide triggers
#2
#2
3
32
Edge of paper to back of door
Orilla del papel para la parte posterior de la puerta
Du bord du papier à l’arrière de la porte
Doble aquí para que entre en el gabinete
Pliez ici pour adapter à l’armoire
12400 Earl Jones Way
Louisville, KY 40299
rev-a-shelf.com
Customer Service: 800-626-1126
FOOD STORAGE CONTAINER FLOOR TEMPLATE 24”
PLANTILLA DE PISO DE 61CM (24”) PARA EL CONTENEDOR DE ALMACENAMIENTO DE ALIMENTOS
MODÈLE DE PLANCHER POUR LES CONTENANTS POUR RANGEMENT DES ALIMENTS 61CM (24”)
Center line of
cabinet opening
Línea central para la apertura del gabinete
Ligne centrale de l’ouverture de l’armoire
1) Place template into cabinet and position front edge to the back of your door.
a. Inset door - Set back the thickness of your face frame
b. Overlay - Place at the front outside edge of cabinet
2) Usinganawlorpencil,markthroughthebolddottedscrewlocationsontoyourcabinetoor.Removetemplatewhendone
3) Layyourassembledslidesetoverthetopofthemarkedholesandusingtheprovided8screws,attachtheslidestothecabinetoor
thru the grey slide feet holes
4) Place your FSCO wood box with attached triggers on top of the slides and push back until you hear the “click” sound. You are now
ready to organize your FSC drawer.
1) Coloque la plantilla dentro del gabinete y posiciónela a la orilla frontal en donde la parte posterior de la puerta va a estar colocada.
Placez le modèle dans l’armoire et position nez le bord avant à l’endroit où l’arrière de votre porte sera
a. Inserto de puerta = ponga en su lugar el grosor de la puerta.
Porte encastrée = placez en retrait de l’équivalent de l’épaisseur de votre porte
b. Plantilla = colóquela a la orilla frontal del gabinete.
Porte avec appliqué = placez au bord de l’avant de l’armoire
2) Utilizando una lezna o un lápiz, marque a través de las ubicaciones de tornillo que se encuentran punteadas dentro del gabinete.
Cuando acabe, quite la plantilla.
En utilisant un poinçon ou un crayon, marquez à travers les emplacements des vis en pointillés gras sur le plancher de votre armoire.
Enlevez le modèle quand vous avez terminé.
3) Coloqueeldeslizanteensambladoencimadelosoriciosmarcados,yutilizandolosochotornillosqueseproveen,sujetelos
deslizantesalpisodelgabineteatravésdelosoriciosdeldeslizantegrisdelpie.
Posezvotrecoulisseassembléesurledessusdestrousmarquésetenutilisantles8visfournies,xezlescoulissessurleplancherde
l’armoire à travers les trous des pieds gris de la coulisse.
4) Coloquelacajademaderadelorganizadordecontenedoresparaalmacenaralimentos(FSCOporsussiglaseninglés)conlos
gatillossujetosenlapartesuperiordelosdeslizantesyempujehaciaatráshastaqueescucheunsonido.Ustedyaestálistopara
organizarelcajóndecontenedoresparaalmacenaralimentos.
Placez votre boîte en bois FSCO avec les gâchettes attachées sur le dessus des coulisses et poussez vers l’arrière jusqu’à ce que
vous entendiez le son «clic». Vous êtes maintenant prêt à organiser votre tiroir FSC.
Fold here to t cabinet
T-4FSCO-0816
FIGURE 2.1 FIGURE 2.2
FIGURE 3
Customer Service: 800-626-1126 | rev-a-shelf.com
1
Page is loading ...
  • Page 1 1
  • Page 2 2

Rev-A-Shelf 4FSCO-18SC-1 Operating instructions

Rev-A-Shelf
Brand
Rev-A-Shelf
Model
4FSCO-18SC-1
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents