2. WatchDog
  3. NXT600c
NXT600c

WatchDog NXT600c User manual

  • Hello! I've reviewed the user guide for the Seaira Global NXT 600c/85c Control Board. This document provides detailed instructions on how to change the control board including steps for removing the side panel, unplugging the wires and screws locations. I am ready to answer any questions you may have about this process.
  • What tools are needed to change the control board?
    What is the first step in replacing the control board?
    How many screws hold the control board in place?
Tools:
•Phillips Head Screwdriver
-OR-
•#2 Phillips Drill (Optional)
•Replacement Control Board
1. Remove the side panel so you have access to the control board (the side with the sensor
vents). For more details, check out the “How to Remove the Side Panels” Guide.
2. Remove the two screws from the control board cover and lift off the cover.
Seaira Global • 14021 NC Highway 50 • Surf City, NC 28445
www.seairaglobal.com
How to Change the Control Board
WatchDog
NXT
85
600
c
/
c
Seaira Global • 14021 NC Highway 50 • Surf City, NC 28445
www.seairaglobal.com
Seaira Global • 14021 NC Highway 50 • Surf City, NC 28445
www.seairaglobal.com
/