•Removebottomboltfromeachsideof

 handle(belowtriangleshapedthumb

 simplyre-attach(seeFigureA).

•Besuregatecontrolisintheclosedposition(donotholdbaildownwhenlling)

•Determineappropriatesettingformaterialbeingusedbyreadingthesuggestedsettingonthematerial’sbag.

 Besuretoreadtheinstructionsonthebag/boxofthematerialyou’respreadingtoidentifyaccuratesettingneeded)

•Tobeginspreading,startwalking(about3mphpace)andpullthebailsystemdowntoopengate

•Tostopspreadingsimplyletgoofthebailandthegatewillclose

•Whennishedspreadingemptyhopperofanyremainingmaterial

•oroughlywashspreaderandallowtodrybeforestoring

•Adjustbaebyhandtoblockdistributionaccordingly.Frontandsidescanbeadjustedindependently.

•Usewingnutstoadjusttensiononbaes.