Connect a network cable to the WAN port of the AIP-W525H
If you have a modem, simply connect the other end into the modem’s jack.
If you have an existing Router, connect the other end to a LAN port of that
one.
You'll be on the internet in a few seconds.
You can also connect to the new wireless network created previously,
named Wifi_Alfa in this example.
Setup is done!
PS.
If you use the AIP-W525H on an existing router, it would be useful to know
the IP address of that Router, but not absolutely necessary, we use
192.168.3.1 here, which is not used by manufacturers as Router address,
(Important: third number must be different from main Router’s ip, egg:
main router 192.168.1.1 and second Router 192.168.2.1 .
To know the current address of your existing router, use the CMD
command:
[under Windows7 = Start / Search, type cmd]
[Windows XP = Start / Run, type cmd]
in the new window, type ipconfig and press the Enter key, the default
gateway is the address of your
Router.
Important note:
This setup Guide is free to use or give away, but do not modify it!
If you buy Alfa products from us they come pre-configured for your needs
with 100% FREE support.
If you buy the product else were, we still can help you but charges are
applied.