Broan Outdoor Thermostat Kit Installation guide

Outdoor Thermostat Kit
Broan
Brand
Broan
Model
Outdoor Thermostat Kit
Type
Installation guide
Outdoor Thermostat Field Installation for 14 & 16 SEER Heat Pumps
IMPORTANT SAFETY INFORMATION
INSTALLER: Please read all instructions before servicing
this equipment. Pay attention to all safety warnings and
any other special notes highlighted in the manual. Safety
markings are used frequently throughout this manual to
designate a degree or level of seriousness and should not
be ignored. WARNING indicates a potentially hazardous
situation that if not avoided, could result in personal injury
or death.
WARNING:
ELECTRICAL SHOCK, FIRE OR
EXPLOSION HAZARD
Failure to follow safety warnings exactly could
result in serious injury or property damage.
Improper servicing could result in dangerous
operation, serious injury, death or property
damage.
• Before servicing, disconnect all electrical power
to the unit.
• When servicing controls, label all wires prior
to disconnecting. Reconnect wires correctly.
• Verify proper operation after servicing.
14 & 16 SEER HEAT PUMPS
The instructions listed below describe how to properly
install the outdoor thermostat that is required by HUD in
split system and packaged unit heat pump applications.
See Figure 1.
NOTE: Please refer to the installation instructions supplied
with the unit for proper wiring of the outdoor thermostat.
All wiring and quick connect terminals needed to install
the outdoot thermostat are filed supplied. Thermostat
terminal designations may vary.
1. Using a 5” long wire (with ¼” quick connect receptacle
terminal on both ends), connect one end of the quick
connect terminal to the outdoor thermostat (ODT) and
connect the other end to the W2 IN terminal on the defrost
board.
2. Place a ¼” quick connect receptacle terminal to the field
thermostat wire W2 from the thermostat. Connect the quick
connect terminal to the outdoor thermostat (ODT).
3. Using a cable tie, bundle the suspended outdoor thermostat
to the low voltage wire bundle in the control box.
INSTALLATION INSTRUCTIONS
Thermostat
Red
White
Black
Air Handler
Outdoor
Heat
Pump
OUT
IN
R
W
C
O
Y
R
G
C
O
Y
O
C
R
W2
W2
Y1
IN
Green
G
W2
E
ODT
Figure 1. Indoor Thermostat Hookup
13 SEER HEAT PUMPS
The instructions listed below describe how to properly
install the outdoor thermostat on 13 SEER heat pumps.
1. Connect one side of the wire (1) to a terminal on the
Outdoor Thermostat (2). See Figure 2.
2. Connect the terminal adapter (3) to the free terminal on
the ODT (2).
3. Connect the free end of the wire (1) to the “W2” on the
Defrost Board and the terminal (3) to the “E” on the Defrost
Board.
10186250
(NEW)
Specifications & illustrations subject to change without notice or incurring obligations (11/17).
O’Fallon, MO, © Nortek Global HVAC LLC 2017. All Rights Reserved.
E
T1
T2
C
Y
O
W 2
R
1
2
3
DF1 DF2
DFT
Figure 2. Outdoor Thermostat Hookup
  • Page 1 1
  • Page 2 2

Broan Outdoor Thermostat Kit Installation guide

Outdoor Thermostat Kit
Broan
Brand
Broan
Model
Outdoor Thermostat Kit
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents